Idiomas disponibles
Idiomas disponibles
CAUTION: Before you begin trimming, only use the
appropriate type of cutting line. Ensure that cutting
line is present in both sections of the spool as shown
in Figure S.
11. Once both lines are wrapped around the spool
your thumb and finger on the holding slots to further
secure the string and feed the end of each line through
the two holes
43
on either side of the head in the spool
housing
12
as shown in figure T.
12. Line up the white nubs
the recesses
of the spool. Align the holding slots
42
with the two holes as close as possible.
13. Push the spool into the spool housing and turn
counterclockwise to lock the spool in place. Ensure the
white nub appears in the spool window
the line doesn't unravel and wrap around the shaft below
the spool.
14. Pull both ends of the cutting line to release them from the
holding slots. If the line extends past the cutting blade on
the guard cut the line so it just reaches the blade.
MAINTENANCE (Fig. U)
Your D
WALT power tool has been designed to operate
e
over a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper tool
care and regular cleaning.
WARNING: To reduce the risk of serious personal
injury, turn tool off and disconnect battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start‑up can cause injury.
1. Keep the air intake slots
avoid overheating.
2. Your trimmer line can dry out over time. To keep your
line in top condition, store spare line in a plastic, sealable
bag with a tablespoon of water.
3. Plastic parts may be cleaned by using a mild soap and a
damp rag.
4. The line cutter on the edge of the guard can dull over
time. It is recommended you periodically touch-up the
sharpness of the blade with a file.
The charger and battery pack are not serviceable.
Cleaning
WARNING: Blow dirt and dust out of all air vents with
clean, dry air at least once a week. To minimize the
risk of eye injury, always wear approved eye protection
when performing this procedure.
WARNING: Never use solvents or other harsh
chemicals for cleaning the non‑metallic parts of the
tool. These chemicals may weaken the plastic materials
used in these parts. Use a cloth dampened only with
water and mild soap. Never let any liquid get inside the
tool; never immerse any part of the tool into a liquid.
36
inside the spool housing with
37
38
. Make sure
, shown in figure U, clean to
44
Accessories
WARNING: Since accessories, other than those
offered by D
product, use of such accessories with this tool could
, place
be hazardous. To reduce the risk of injury, only
D
WALT‑recommended accessories should be used
e
with this product.
Recommended accessories for use with your tool are
available at extra cost from your local dealer or authorized
service center.
39
Repairs
The charger and battery pack are not serviceable.
WARNING: To assure product SAFETY and RELIABILITY,
repairs, maintenance and adjustment (including brush
inspection and replacement) should be performed by a
D
WALT factory service center or a D
e
service center. Always use identical replacement parts.
DCSB970
WALT, have not been tested with this
e
SPECIFICATIONS
ENglish
WALT‑authorized
e
60V Max*
35
