Idiomas disponibles
Idiomas disponibles
OPERATION
USING THE TRIGGER MODE SELECTOR
See Figures 5 - 6, page 13.
WARNING:
Never wedge or hold back the workpiece contact
mechanism during operation of the tool. Doing so
could result in possible serious injury.
This tool is shipped from the factory with the trigger mode se-
lector set in the Single Sequential Actuation mode. The trigger
mode selector can also be set for Contact Actuation mode.
SINGLE SEQUENTIAL ACTUATION MODE
Single sequential actuation provides the most accurate
fastener placement.
Remove the battery pack.
Slide the trigger mode selector all the way to the right.
Reinstall the battery pack.
Grip the tool firmly to maintain control. Position the nose
of the tool onto the work surface.
Push the tool against the work surface to depress the
workpiece contact.
Squeeze the trigger to drive a fastener.
Allow the tool to recoil away from the work surface as the
fastener is driven.
NOTE: The trigger must be depressed within 3 seconds
of placing the nose of the tool against the workpiece. If
depressing the trigger does not drive a fastener, lift the tool
away from the workpiece, then replace and try driving the
fastener again.
CONTACT ACTUATION MODE
Contact actuation allows very fast repetitive fastener place-
ment.
Remove the battery pack.
Slide the trigger mode selector all the way to the left.
Reinstall the battery pack.
Grip the tool firmly to maintain control.
Squeeze and hold the trigger. Push the tool against the
work surface to depress the workpiece contact and drive
a fastener.
Allow the tool to recoil away from the work surface as the
fastener is driven.
NOTE: In Contact Actuation Mode, the tool may also be
operated by depressing the workpiece contact against
the surface and squeezing the trigger. The nose of the tool
must be pressed against the workpiece within 3 seconds of
depressing the trigger. If pressing the nose to the workpiece
does not drive a fastener, release the trigger, depress the
trigger again, then try driving the fastener again.
WARNING:
During normal use the tool will recoil immediately
after driving a fastener. This is a normal function
of the tool. Do not attempt to prevent the recoil
by holding the nailer against the work. Restriction
to the recoil can result in a second fastener being
driven from the nailer. Grip the handle firmly, let the
tool do the work, and do not place second hand on
top of tool at any time. Failure to heed this warning
can result in serious personal injury.
DRIVE DEPTH ADJUSTMENT
See Figure 7, page 13.
The driving depth of the nail may be adjusted by rotating the
dial clockwise to increase or counterclockwise to decrease
the depth the nail is driven. It is advisable to test the depth
on a scrap workpiece to determine the required depth for
the application and to drive a test nail after each adjustment
until the desired depth is set.
REMOVING NAILS FROM THE TOOL
See Figure 8, page 13.
Remove the battery pack.
WARNING:
Remove the battery pack from the tool before
removing nails. Failure to do so could result in
serious personal injury.
To remo ve a strip o f na ils f ro m the to o l, lift the latch at
the rear of the magazine and slide the magazine open.
Remo ve the na il strip .
CLEARING A JAMMED BRAD NAIL
If a brad nail becomes jammed:
Remove the battery pack.
Open the magazine latch and remove the nail strip from
the magazine.
Remo ve ja mmed o r bent bra d na ils f ro m the no se a rea
or the nail channel.
Push the magazine cover closed until it securely snaps
into place and replace the battery pack.
9 - English
