Idiomas disponibles
Idiomas disponibles
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in
death, fire, or electrical shock.
Before you move your refrigerator into its final location, it is
important to make sure you have the proper electrical
connection:
@
Ill&
Recommended
Grounding
Method
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused,
grounded electrical supply is required. It is recommended
that a separate circuit serving only your refrigerator be
provided. Use an outlet that cannot be turned off by a
switch. Do not use an extension cord.
NOTE: Before performing any type of installation, cleaning,
or removing a light bulb, turn the Thermostat Control (or
Refrigerator Control depending on the model) to OFF and
then disconnect the refrigerator from the electrical source.
When you are finished, reconnect the refrigerator to the
electrical source and reset the Thermostat Control (or
Refrigerator Control) to the desired setting.
Electrical Shock Hazard
Disconnect power before removing doors.
Failure to do so can result in death or
electrical shock.
NOTE: Before removing doors, open both doors and
remove base grille (see the "Base Grille" section).
Tools Needed:
V4-inch hex-head socket wrench and 5/_6-inch hex-head
socket wrench.
1. Unplug refrigerator or disconnect power supply.
2. If you have a dispenser (ice or water), disconnect water
line (behind base grille).
•
Remove hose from clip.
•
Disconnect union nut and slide it back onto tube.
•
Remove metal insert from tube.
•
Remove union nut and spring.
\
3. Remove left top hinge.
•
Remove hinge cover and screws. DO NOT
REMOVE SCREW 1 AS SHOWN IN DIAGRAM.
•
Disconnect wiring plug and both ground wires.
•
Carefully lift door up off bottom hinge. Make sure
you protect water line from damage.
6
