Panasonic TY-ST65PE7 Manual De Instrucciones página 17

Pedestal
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 30
Assembly Procedure
3. Display Overturn-Prevention
Anchor the display to both the base and the wall surface.
Anchoring to the base
Attach the overturn-prevention belt
hole at the rear of the pedestal, and then use a wood screw
When attaching to the base, insert the wood screws into the prepared holes.
If there are no prepared holes, drill new holes to the center of the base board width.
(Screw
tightening torque: 1.2 to 1.5 N•m)
Anchoring to the wall
Use a sturdy string, wire, or other such
commercially available item through
the hole on the display, and anchor the
string, etc., to a secure wall or pillar.
[For safety reasons, always use the overturn/fall prevention accessories]
The equipment may overturn in the event of an earthquake etc. Therefore, always use the overturn/fall prevention
accessories.
The details in this section indicate how to reduce any damage or injury caused by this equipment
overturning or falling due to an earthquake. However, there is no guarantee that the overturn/fall
prevention accessories will be effective in all earthquake situations.
(Cont'd)
(1 belt) to the pedestal using a screw
Through hole on the display
(1 screw) through the screw
(1 screw) to anchor the belt to the base.
Wire (commercially available), etc.
Screw
Wood screw
Band
Wire (commercially available), etc.
Surface of wall
17
Tabla de contenido
loading

Tabla de contenido