Vortice VORT INVISIBLE MINI Manual De Instrucciones página 35

2 Product description
VORT INVISIBLE MINI is 3-speed (Min, Max, Holiday) residential heat recovery unit + bypass (mechanical in the
case of EVO and TOP models) + humidity sensor (TOP models). The unit is designed to continuously remove
stale air from rooms by means of a system of fixed piping and grilles. The heat is recovered from the air suctioned
from the room by means of a high-performance heat exchanger, which transfers is to the incoming cool air. The
flow rate of the ventilation can increase up to "Max" mode, for example if there is a high amount of humidity in
the room. The extracted air is discharged outside by means of a single duct to a grille. The frame is made of
galvanized painted steel. The internal sides of the housing are made in expanded polypropylene.
The heat recovery unit is also equipped with a filter maintenance warning system. (for more information refer to
section 13.5).
3 Compliance
- These appliances are designed for use in residential and commercial
properties.
- This appliance can be used by children aged from 8 years and above
and persons with reduced physical, sensory or mental capabilities
or lack of experience and knowledge if they have been given
supervision or instruction concerning use of the appliance ina safe
way and understand the hazards involved. Children shall not play
with the appliance. Cleaning and user maintenance shall not be
made by children without supervision.
- The installation of the flush-mounted box for the remote display must
only be carried out by professionally qualified personnel.
- If the power supply cable is damaged, have it replaced without delay
by a VORTICE authorised Technical Support Centre.
- The appliance internal parts must be cleaned only by a skilled
professional.
- The appliance must be installed by a professionally qualified
electrician only.
- Ensure that the electrical system to which the appliance is connected
complies with applicable standards.
- An omnipolar switch with a contact opening distance of 3 mm or higher
should be provided for installation, enabling complete disconnection
under overvoltage category III conditions.
- Products equipped with single-phase wiring (M) engines ALWAYS
require connection to 220-240V (or only 230V where required) single-
phase lines. Any kind of modification shall be considered as product
tampering and shall nullify the relative Warranty.
- Precautions must be taken to prevent the backflow of gas from the
gas exhaust pipe or other fuel-burning appliances into the room.
ENGLISH
35