Vortice VORT INVISIBLE MINI Manual De Instrucciones página 60

ENGLISH
To re-insert the condensate collection tray, first raise the exchange pack by about 3 cm to avoid damaging the
seals.
Then insert the fittings into the holes and push the tray and the exchange
pack to the bottom. (fig.16).
13.3 Replacement of the electronic board
To replace the elctronic board, it is possible to remove it from the machine
by turning the plate tab and pulling the card towards you. (fig.17).
17
13.4 Maintenance (recommended)
Remove all dust etc. from both the impellor and the motor, taking care not to disturb the balance of the fan. Refit
or replacement is in reverse order.
13.5 Filter cleaning (fig. 18)
The machine is equipped with a "Filter cleaning signal", indicated by an alarm on the display supplied with the
machine. In the presence of this alarm, the machine signals that the filters are dirty or to be replaced.
Remove the filters, first removing the magnetic covers,cleaning them or replacing them and putting them back
in the machine. Then reset the filter cleaning alarm through the special alarm menu in the main menu of the
control panel display.
Remove all debris with a soft brush or hoover.
60
16
3cm
18