PART LIST
EN
1. Belt guidance 2
2. Seat cover
3. Shoulder pad
4. Shoulder strap
5. Buckle tongue
6. Straps release button
7. Buckle
8. Crotch pad
9. Sleeping pad
10. Press button
11. Adjuster strap
12. 360° rotate adjuster
13. Headrest
14. Belt guidance 1
15. Recline handle
16. Base
17. Headrest adjust button
18. Blue guidance
19. Connector
20. Top tether clip
21. Metal link
22. Top tether adjuster button
23. ISOFIX locking arms
24. ISOFIX attachment point
25. ISOFIX release button
USAGE
5-POINT HARNESS USE
1.
Hold both buckle tongues. The right side should be slightly upper.
2.
Snap two buckle tongues together. Pay attention to the back and front of the buckle tongues.
3.
Slide towards buckle for tightening of the harness. You should hear an audible CLICK.
4.
Tighten the harness straps. Check that buckle is fastened.
5.
To tighten the harness, first, pull up the shoulder straps and the lap straps will tighten. Then, pull on the adjuster strap. Pull any excess
the harness webbing through the buckle towards the child's shoulders and pull on the adjuster strap. This may need to be repeated
several times for proper fit.
6.
Verify that the harness is snug around the child's waist and shoulders. After tightening the straps, adjust the shoulder pads to the
appropriate position on the chest. Check that the crotch pad is not bent or crooked.
NOTES:
• Tighten the straps as tightly as possible without causing any discomfort to the child.
• A snug harness cannot be pinched, and should not allow any slack.
• Ensure the harness is snug around the child and lays flat.
• Ensure that nothing interferes with the harness.
• The lap straps should be as low as possible, close to your baby's crotch, not the belly.
WARNING: Loose straps are dangerous. Serious injury or death could occur to a child that is not secured
properly. Ensure that the straps are adjusted properly.
7.
To loosen the harness, press on the harness release button while pulling forward on the shoulder straps.
8.
Press the straps release button to release the buckle tongues. Separate chest clip and spread the
harness straps apart.
HEADREST ADJUSTMENT
1.
With the loose harness, press the headrest adjusts button, and move the headrest up or down to the
desired position.
2.
Release adjust button and slide headrest slightly up or down to lock into the appropriate use position.
NOTE: Headrest has 7 height positions. The height can be changed for child comfort.
• Positions 1-6 are for groups: 0+ (birth to 13 kg), I (9 to 18 kg).
• Positions 7 is for groups: II, III (15 to 36 kg).
NOTE: A correctly adjusted headrest ensures optimal protection of the child in the child restraint. Adjust
the headrest so that the shoulder straps are at the same level as your child's shoulders.
40
1
1
2
3
4
5
6
7
8
9
10
11
12
17
18
19
20
21
22
23
24
2
13
14
15
16
25
3
4