Parkside PMFS 200 C3 Traduccion Del Manual De Instrucciones Originale página 9

Appliance-specific safety instructions
■ Secure the workpiece. A workpiece securely
held by a clamping device or vice is much safer
than one held in your hand.
■ Do not rest your hands next to or in front of the
appliance and the area being worked as there
is a risk of injury if you slip.
■ In the event of danger, remove the mains plug
from the socket immediately.
■ Always route the power cable towards the rear,
away from the appliance.
■ RISK OF FIRE DUE TO FLYING SPARKS! If
you sand metal, sparks will be produced. There-
fore, make sure that nobody is at risk and that
no combustible materials are located in the
immediate vicinity of where you are working.
■ Hold the power tool by the insulated gripping
surfaces, as the grinding surface could hit its
own cable. Damage to a live wire may make
exposed metal parts of the power tool live and
could give the operator an electric shock.
WARNING! TOXIC VAPOURS!
► Working with the tool can produce harmful/
toxic dusts that represent a health hazard for
the person operating the appliance and for
any other people in the area.
WARNING! RISKS DUE TO DUST!
► When working for extended periods of time
on wood and, in particular, materials that
produce dust which is hazardous to health,
connect the appliance to an appropriate
external dust extraction appliance. Wear
safety goggles and a protective dust mask!
■ Ensure sufficient ventilation when working on
plastics, paints, lacquers, etc.
■ Do not soak the materials or the area to be
processed with liquids containing solvents.
■ Never work on moistened materials or damp
surfaces.
■ Avoid sanding lead paint or other harmful
materials.
PMFS 200 C3
■ Materials containing asbestos must not be
processed. Asbestos is a known carcinogen.
■ Avoid contact with the sanding sheet while the
appliance is running!
■ Do not use the appliance without a sanding
sheet fitted.
■ Never use the appliance for other purposes and
only use original parts/accessories. Using
attachments or accessory tools other than those
recommended in the operating instructions can
lead to a risk of injury.
■ Always allow the appliance to come to a
complete standstill before putting it down.
■ The appliance must always be kept clean, dry
and free from oil or grease.
Before use
Fitting/changing the sander plate
WARNING!
► Always remove the plug from the mains
power socket before carrying out any work
on the appliance.
♦ Use the appropriate sander plate
the corresponding application.
♦ Remove the four screws
hex key .
♦ Remove the pre-fitted sander plate.
NOTE
► The orbital sander plate
to the appliance in one direction. Please pay
attention to the arrow marks on the orbital
sander plate . These must point forwards.
With the delta sander plate
forwards.
► The rubber pins
The groove must be aligned with the tabs in
the mounting holes on the respective sander
plate . This allows you to insert the
rubber pins into the sander plate
using the supplied
can only be fitted
the tip points
have a groove on the side.
GB │ IE │
for
.
5 ■