Repetitive Crosscutting - Bosch GTS1041A Instrucciones De Funcionamiento

Tabla de contenido

Idiomas disponibles

cutting" operations (when saw blade cuts entirely

through the thickness of the work piece). Replace

guard IMMEDIATELY after completion of dadoing

or rabbeting cuts.

Have blade extend approximately 1/8" above top

of work piece. Additional blade exposure would

increase the hazard potential.

Do not stand directly in front of the blade in case

of a THROWBACK (small cut-off piece caught by

the back of the blade and thrown toward the op-

erator). Stand to either side of the blade.

Keep your hands clear of the blade and out of the

path of the blade.

If blade stalls or stops while cutting, TURN

SWITCH OFF before attempting to free the blade.

If excessive pressure is applied or a dull blade is

used, the drop arm may drop while cutting or dur-

ing transportation. If this occurs, turn the tool off

using the power switch and follow the instructions

to reset the system on page 13.

Do not reach over or behind the blade to pull the

work piece through the cut, to support long or

heavy work pieces, to remove cut-off pieces of

material or FOR ANY OTHER REASON.

Do not pick up small pieces of cut-off material

from the table. REMOVE them by pushing them

OFF the table with a long stick. Otherwise they

could be thrown back at you by the rear of the

blade.

Do not remove small pieces of cut-off material

that are close to or may become TRAPPED in-

side the blade guard while the saw is RUNNING.

THIS COULD ENDANGER YOUR HANDS or

cause a KICKBACK. Turn the saw OFF. After the

blade has stopped turning, lift the guard and re-

move the piece.

If work piece is warped, place the CONCAVE

side DOWN. This will help prevent it from rocking

while it is being cut.

The graduations on the miter gauge provide ac-

curacy for average woodworking. In some cases

where extreme accuracy is required, when mak-

ing angle cuts, for example, make a trial cut and

then recheck it with an accurate square or pro-

tractor. If necessary, the miter gauge head can be

adjusted (see page 31).

Tip: The space between the miter gauge bar and

the groove in the table is held to a minimum dur-

ing manufacturing. For maximum accuracy when

using the miter gauge, always "favor" one side of

the groove in the table. In other words, don't move

the miter gauge from side to side while cutting but

keep one side of the bar riding against one side

1600A009XC 09-15.indb 32

Fig. 52

of the groove.

When cutting long workpieces, make sure the

end is sup ported from the floor.

Tip: Glue a piece of sandpaper to the face of the

miter gauge head. This will help prevent the work

piece from "creeping" while it is being cut.

The miter gauge may be used in either of the

grooves in the table. Make sure it is locked.

When using the miter gauge in the LEFT hand

groove, hold the work piece firmly against gauge

head with your left hand, and grip the lock knob

with your right hand.

When using the RIGHT hand groove, hold the

work piece with your right hand and the lock knob

with your left hand.