Idiomas disponibles
Idiomas disponibles
9.Maintenance
1. Lubrication
After the running belt has been used for a period of time, it must be
lubricated with a specially configured methyl-silicone oil.
Advice:
Less than 1 hour per week
Less than 3 hours per week
3 to 6 hours per week
Do not over-lubricate, the more lubricant is not the better.
Remember: Reasonable lubrication is an important factor in improving the
service life of the treadmill.
2. As for the way to check whether you need to apply lubricant again,
just grab the running belt and touch your hand to the center of the
back of the running belt as much as possible. If your hands are
stained with silicone (somewhat moist), it means that no more
lubricant is needed. If the running board is dry and there is no
methyl-silicone oil in the hands, you need to add lubricant.
★ The steps to apply lubricant to the running board: (as shown in the
picture);
★ Stop the running belt and fold the machine;
★ Lift up the running belt on the bottom, extend the oil into the middle of
the running belt as much as possible, spray methyl-silicone oil on the inner
side of the running belt, and coat both sides of the running belt with
methyl-silicone oil;
★ Use the speed of 1km/h to run the treadmill to evenly apply the
methyl-silicone oil, and lightly step on the running belt from left to right, and
the methyl-silicone oil can be completely absorbed by the running belt after
about a few minutes.
Lubricate once every 6 months
Lubricate once every 3 months
Lubricate once every 2 months
18
