Idiomas disponibles
Idiomas disponibles
Begin procedure
1. Open the washer door and remove any clothing or items from
the washer.
2. Close the washer door.
3. Open the dispenser drawer and immediately add 2/3cup
(160 mL) of liquid chlorine bleach to the bleach compartment.
NOTE: Do not add any detergent to this cycle. Use of more
than 2/3cup (160 mL) of bleach will cause product damage
over time.
4. Be sure the dispenser drawer is closed.
5. Select the CLEAN WASHER cycle.
6. Press START.
NOTE: The basket will rotate, then the door will unlock, lock
again, and then the cycle will continue.
•
The machine will not fill, but the basket will rotate while
the washer runs a short sensing cycle. This will take
approximately
3 minutes.
7. The cycle will determine whether clothing or other items are
in the washer.
a)
b)
If no items are detected in the washer, it will proceed
to Step 8.
If any items are detected in the washer, "rL" or "F-34"
will be displayed, and the WASH and CONTROLS
LOCKED lights will remain lit. The door will unlock.
•
Press STOP to cancel the failure code. Then
repeat steps 1,2 and 6 to start the cycle again.
8. Once the cycle has begun, allow the cycle to complete.
9. After the cycle is complete, leave the door open slightly, to
allow for better ventilation and drying of washer interior.
Always do the following to maintain washer freshness
•
Use only HE High Efficiency detergent.
•
Leave the door slightly open after each cycle to allow for
better ventilation and drying of washer interior.
•
Run this procedure on a monthly basis using 2/3cup (160 mL)
of liquid chlorine bleach.
•
If the procedure does not sufficiently improve the machine
freshness, evaluate your installation and usage conditions for
other causes.
Cleaning the exterior
Use a soft damp cloth or sponge to wipe up any spills.
Occasionally wipe the outside of your washer to keep it looking
new. Use mild soap and water. Do not use abrasive products.
Cleaning
the dispenser
drawer
The dispenser drawer is removable for easy cleaning.
1. Unlock the dispenser drawer by pressing the Release Lever in
the Prewash compartment.
See "Using the Dispenser."
Remove the drawer.
2. Remove the inserts (the siphon from the softener and bleach
compartments
and the selector).
3. Wash the parts under running water.
4. Replace the inserts and return the dispenser to the drawer.
Replace inlet hoses after 5 years of use to reduce the risk of hose
failure. Periodically inspect and replace inlet hoses if bulges,
kinks, cuts, wear or leaks are found.
When replacing your inlet hoses, record the date of replacement.
Install and store your washer where it will not freeze. Because
some water may stay in the hoses, freezing can damage your
washer. If storing or moving your washer during freezing weather,
winterize it.
Non-use
or vacation
care:
Operate your washer only when you are at home. If you will be on
vacation or not using your washer for an extended period of time,
you should:
•
Unplug washer or disconnect
power.
•
Turn off the water supply to the washer. This helps avoid
unintended flooding (due to a water pressure surge) while you
are away.
•
Slightly open door to provide ventilation.
To winterize
washer:
1. Put 1 qt (1 L) of R.V.-type antifreeze in the drum.
2. Run washer on a Drain & Spin cycle.
3. Unplug washer or disconnect
power.
4. Shut off both water faucets.
5. Disconnect
water inlet hoses from faucets and drain.
To use washer
again:
1. Flush water pipes. Reconnect water inlet hoses to faucets.
Turn on both water faucets.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension
cord.
Failure to follow these instructions can result in death,
fire, or electrical
shock.
2.
3.
Plug in washer or reconnect power.
Run the washer through the Normal/Casual
cycle with V2the
manufacturer's
recommended
amount of HE detergent for a
medium-size
load, to clean the washer and remove the
antifreeze, if used.
21
