Idiomas disponibles
Idiomas disponibles
Installation
Instructions
USE TOP CABINET TEMPLATE
FOR PREPARATION
OF TOP
CABINET
You need to drill holes for the top support
screws,
a hole large enough
for the power cord to fit through
and a cutout large enough
for the exhaust adapter.
• Read the instrucdons
on the TOP CABINET
TEMPLATE.
• Tape it underneath
the top cabinet.
• Drill the holes, following the instructions
on the
TOP CABINET TEMPLATE.
CAUTION: Wear safety goggles when drilling holes
in the cabinet
bottom.
[_
ADAPTING
BLOWER
FOR TOP EXHAUST
_J] Remove and save screws that hold blower plat e to
the oven.
,_
_ -'<-- Blower P lateScrews
tl
._-
Back of Oven
_]
Slide the blower plate from under its retaining
flange and lift it off. Remove and save screw that
holds the blower motor to oven.
Retaining
"_
BlowerPlate
Screw
[]
Carefully.
pull out the blower
unit.
The wires
will extend
far enough
to allow you to adjust
the
blower
trait.
[]
Roll the blower unit 90 ° so that fan blade openings
are facing up.
R011
NOTE:
Make sure wires remain
routed
in the
grooves
of the motor
frame.
20
