Idiomas disponibles
Idiomas disponibles
Installation Instructions
To use toggle
bolts:
Mounting
Plate
Spacingfor TogglesMore
ThanWall Thickness
Toggle Wings
all
Bolt End
[]
Place the mounting
plate against file wall and
insert the toggle wings into the holes in the wall
to mount the plate.
NOTE: Before tightening
toggle bolts and wood
screw, make sure the tabs on the mounting
plate
touch the bottom
of the cabinet when pushed
flush
against the wall and that the plate is properly
centered
under
the cabinet.
CAUTION:
Be careful to avoid pinching
fingers
between the back of the mounting
plate and the wall.
[]
Tighten
all bolts. Pull the plate away from the wall
to help tighten
the bolts.
_-]
USE TOP CABINET TEMPLATE
FOR PREPARATION
OF TOP
CABINET
You need to drill holes for the top support
screws and
a hole large enough
for the power cord to fit through.
• Read the instructions
on the TOP CABINET
TEMPLATE.
• Tape it underneath
the top cabinet.
• Drill the holes, following the instructions
on the
TOP CABINET TEMPLATE.
CAUTION:
Wear safety goggles when drilling holes
in the cabinet bottom.
[_
ADAPTING
BLOWER FOR
OUTSIDE
BACK EXHAUST
[_ Remove the three screws that hold the blower plate
to dae oven. Slide blower plate from under its
retaining flange. Remove and save the screw that
holds blower motor to oven.
_V
FRetn_gnei'___
"_r'_- Blower P late
[]
Carefully
pull out the blower
unit.
The wires
will extend
far enough
to allow you to adjust
the blower
unit.
EndA
[]
Roll the blower unit so the fan blade openings
are facing up.
BeforeRolling
After Rolling
[4]
Rotate
blower
unit
counterclockwise
180 °.
Before R otation
After Rotation
3ack o f
Oven
16
