TWINCA ES-500 Manual De Operaciones página 40

Other risks and emergency safety procedures
The electric motor, hydraulic pump and hydraulics become hot during continuous use. Always make sure that
the electric motor, hydraulic pump, tank and cylinders have cooled down before handling these parts.
When driving on inclines, the operator must always be at the highest point of the incline. There is a risk associated
with driving on inclines as material may fall off and the stability of the machine may have changed.
Battery Leak procedure: Wear acid-resistant clothing, boots, gloves, and face visor. Stop the leak and absorb
the acid with e.g. granules or shavings, if possible neutralize with soda, sodium, pulverized lime and etc. Never
drain acid into the nature or sewer. For more information about the battery please contact the manufacturer.
Fire procedure: Due to the components of the machine electric fire may occur, therefore do NOT extinguish the
fire with a water or powder extinguisher. Use foam or CO2 extinguisher.
Procedure for clamping under scissors and dump bed: It is always recommended, to use the machine's
own functions to repair the damage. If this is not possible follow the procedure shown in the "Service and
maintenance" section.
WARNING: Removing the pins without supporting the movable parts, scissors and dump bed will
collapse.
Transport and lifting of the machine
Alway make sure the dump bed is empty before transporting or lifting the machine.
When transporting the machine, it must be fastened to the 4 attachment points in accordance with the applicable
lashing rules.
Lifting of the machine should only be done by skilled personnel who has completed a towing course or other
relevant training. All attachment points must be used when lifting the machine and only approved lifting
gear may be used. Before lifting the machine always check is balance and straps as well as the attachment
gear is seated correctly. Check the straps are not jammed and that the machine is not stuck in the ground.
The 4 attachment points are indicated on the machine with this pictogram.
Proper attachment for transport and lifting is shown in the drawing below.
Attachment for transport Attachment for lifting
TWINCAES5008001-EN 36