Idiomas disponibles
Idiomas disponibles
3. Insert the bare copper or green wire(ground) to the "G"
ground connection of the terminal block and securely
tighten the terminal block screw.
A. Insert the white (neutral) wire to the "N" connection of
the terminal block and securely tighten the terminal
block screw.
5. Insert the black(hot}
wire to the "L" connection
of the
terminal
block and
securely tighten the terminal
block
screw.
6. Check all electrical connections to make sure they are
secure and then attach the junction box cover with the 4
screws.
METHOD
A&B
As a final step, connect the dishwasher power supply plug
(connected to the junction box at the other end) in the slot
at the bottom of the dishwasher as shown
below.
Temperatures required for soldering and sweating will
damage the dishwasher. If plumbing lines are to be
soldered or sweated, keep the heat
source at least 6 inches (152.4 mm) away from
the dishwasher.
INLET WATER CONNECTIONS
Hot Water Supply
The hot water heater should be set to deliver
approximately 120° F (49° C) water to the dishwasher.
Water that is too hot can cause some detergents to lose
effectiveness. Lower water temperatures will increase run
times. The hot water supply pressure must be between
15 - 145 psi (1 - 10 bar).
IMPORTANT NOTES:
«
I using a solder joint instead of a compression
fitting, be sure to make all solder connections before
connecting the water supply line to the dishwasher.
*
Make sure there are no sharp bends or kinks in the
water line that might restrict water flow.
*
Always use the appropriate seal when making
plumbing connections.
¢
Before connecting the water supply line to the
dishwasher, flush the incoming water line for
approximately 5 minutes to clear any foreign material.
*
Turn on the water supply and check for leaks after
connections are made.
Connecting the Hof Water Supply
There are two plastic corrugated hoses that exit the back
of the dishwasher. The larger hose, with the brass fitting
on the end, is the water supply hose to the dishwasher (the
other hose is the dishwasher drain hose). You will need a
3" x 1/2
(7.6 x 4.5cm) opening through the cabinet to
pass the dishwasher water supply line through toward the
shut off valve.
Dishwasher
Water Inlet
Hose
AquaGuard™
Ultimate
water supply hose
