Idiomas disponibles
Idiomas disponibles
PRE - INSTALLATION INSTRUCTIONS
A
WARNING
Avoid Scalding or Electrical Shock Hazard!
Make sure the water supply and electrical supply are
shut off before installation or service.
NOTE: This dishwasher is designed to be enclosed on
the top and both sides by standard residential kitchen
cabinetry.
Select a location as close to the sink as possible for easy
access to water supply and drain lines.
For proper dishwasher operation and appearance, ensure
that the enclosure is square and has the dimensions shown
below.
If the dishwasher is to be installed in a corner, make sure
that there is adequate clearance to open the door.
———
Check clearance
between
dishwasher door
and wall
[1]
Countertop
eT Te
Avoid Electrical Shock/Fire Hazard
Do not allow the electrical and water supply lines to
touch,
After locating the proper place for your new dishwasher,
you will need to make any required openings to allow for
passage of the water, drain and electrical line. In order
to avoid interference with the dishwasher when sliding it
into the cabinet, place your openings within the dimensions
shown below.
\
4-1/2"
(114mm)
2-1/2"
(64mm)
REQUIRED OPENINGS:
Al/
x 2" (10.8 x 5.2cm) - To pass the included electrical
supply junction box through to
an adjacent cabinet
4" x 2" (10 x Sem) -
To
pass
the
included
water
supply
line toward
the water
supply
] Te (3.2cm) diameter -
To pass the dishwasher drain hose
toward the drain connection
NOTE: If the incoming electric supply, water supply and
drain connections are all in the same cabinet, the one
Al?
x 2" (10.8 x 5.2cm) hole will be large enough for all
three to pass through.
Before sliding the dishwasher into the cabinet, remove the
hose clip at the back of the dishwasher, as shown below
and discard.
i
fa
cs og
