Idiomas disponibles
Idiomas disponibles
Installation
Leveling
To protect personal
property
and refrigerator
from damage,
observe the following:
• Protect vinyl or other flooring with cardboard,
rugs,
or other protective
material.
• Do not use power tools when performing
leveling
procedure.
To enhance the appearance
and maintain performance,
the refrigerator
should be level.
Notes:
• Complete any required door reversal, panel
installation
and/or a water supply connection
before leveling.
• Some models only have adjustment
screws (A).
Materials
Needed:
• 3/8"hex head driver
• Carpenter's
level
1. Remove toe grille.
• Grasp firmly and pull outward
to unclip.
2. Using hex head driver, turn front adjustment
screws (A) clockwise to raise and counterclockwise
to lower the front of the refrigerator.
.
Turn both rear adjustment
screws (B) clockwise to
raise and counterclockwise
to lower the rear of the
refrigerator.
4. Using the carpenter's
level, make sure front of
refrigerator
is '/4" (6 ram) or approximately
'/2bubble
higher than back of refrigerator
and that the
refrigerator
is level from side to side.
5. If doors are uneven, do the following:
• Determine
which door needs to be raised.
Turn front roller adjustment
screw (A) clockwise
to raise front corner of door.
If one refrigerator
door has reached
the limit of its
adjustment
range
and doors are still
not level, raise or
lower the opposite
door by turning
roller
adjustment
screw
clockwise or counterclockwise.
0
I
Check with level to verify '/4"tilt to the back for
proper door closure.
If refrigerator
is aligned and stable, replace toe
grille.
Align the toe grille mounting
clips with the lower
cabinet slots.
• Push the toe grille firmly until it snaps into place.
