Kenmore 596.57002600 Guía De Uso Y Cuidado página 27

Ocultar thumbs Ver también para 596.57002600:
Idiomas disponibles

Idiomas disponibles

andCleaning
Replacing Light Bulbs
To avoid electrical
shock which can cause severe
personal injury or death, disconnect
power to
refrigerator
before replacing
light bulb. After
replacing
light bulb, reconnect
power.
To avoid personal
injury or property
damage,
observe the following:
• Allow light bulb to cool.
• Wear gloves when replacing
light bulb.
Upper Fresh Food Section
The upper fresh food light bulbs are located behind the
front panel. Reach behind the panel to remove the
bulbs.
Lower Fresh Food Section
1. Push up on bottom tabs on light
cover. Rotate cover up and release
tabs.
2. Remove light bulb.
3. Replace bulb with appliance
bulb
no greater
than 40 watts.
4. Insert top tabs of light cover into
liner slots and snap bottom tabs
into liner slots.
,f
............
_,
Upper Freezer Section
1. Remove ice bin by
lifting front of bin and
pulling out.
2. Remove light shield by
pressing the upper
right side of the shield and rotating downward.
3. Remove light bulb. Replace with appliance
bulb no
greater
than 40 watts.
4. Rotate the shield upward, press in slightly and
snap into place.
5. Replace ice bin by sliding in until bin locks into
place.
Lower
Freezer
Section
1. Pinch both sides of light cover
to remove.
2. Remove light bulb. Replace
with appliance
bulb no greater
than 40 watts.
3. Pinch both sides of the light
cover to snap into place.
iii_iii;;iiiiii_iiiii_iii_ii!_!_:_
¸ i
Ice and Water
Dispenser
1. Locate light bulb inside top edge
of dispenser frame. Unscrew to
re Ill ove.
2. Replace light bulb with a
7-watt,
120 volt bulb.
Light Bulb
Location
27
loading