Idiomas disponibles
Idiomas disponibles
Installation
.
Pull on tubing to confirm
connection
is secure.
Connect tubing to frame
with water tubing clamp (C)
and turn on water supply.
Check for leaks and correct
if necessary. Continue to
observe the water supply
connection
for two to three
hours prior to moving the
refrigerator
to its permanent
location.
7. Monitor water connection
for 24 hours. Correct
leaks, if necessary.
Handles
Plastic
Handle
To Install:
1. The handles are to be oriented
as shown.
2. Align door handle with the door studs.
3. Ensure the large hole in the mounting
clip is
positioned
down on both ends of the handle.
Metal
Handle
Materials
Needed:
• 3/32" Allen wrench
• Gloves to protect hands
I Note."
Metal handles can scratch doors.
To Remove:
• Loosen set screws in handle using 3/j, Allen
wrench.
• Repeat the procedure
on all screws.
To Replace:
• Align handle with the mounting
posts.
• Apply upward pressure to the handle and hold.
• Fully tighten all set screws to secure handle in
place.
I
Door
Stud
4. Rotate the handle so that the
handle is flat against the door.
5. Grasp the handle firmly and
slide down.
11
