Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Temperature
Controls
Advanced Temperature Control (select models)
(O'F} Recommended
Setting
Order
Replace
o
•
©
The control is located at the top front of the fresh food compartment.
•
Refrigerator
©
(38F)
ar,commer_ded Selting
Initial Temperature
Setting
Temperatures
are preset at the factory at 38 ° F (3° C)
in the fresh food compartment
and 0° F (-17 ° C) in the
freezer compartment.
Adjusting
the Control
24 hours after adding food, you may decide that one
or both compartments
should be colder or warmer.
If
so, adjust the control as indicated
in the Temperature
Control Guide below.
• The first touch of the _^_ or _v_ pads shows the
current temperature
setting.
• The display will show the new setting for
approximately
three seconds, and then return to the
actual temperature
currently within that
compartment.
• Do not change either control more than one degree
at a time.
Allow temperature
to stabilize for 2/4 hours
before making a new temperature
adjustment.
Temperature
Control Guide
Refrigerator
too cold
Refrigerator
too warm
Freezer too cold
Freezer too warm
Turn refrigerator
OFF
Set the Refrigerator
control
to next higher number by
pressing the _^_ pad.
Set the Refrigerator
control
to next lower number by
pressing the _V_ pad.
Set the Freezer control to
next higher number by
pressing the _^_ pad.
Set the Freezer control to
next lower number
by
pressing the _v_ pad.
Press the Freezer _^_ pad
until OFF appears in the
display.
Press either the
Freezer or Refrigerato@
pad to turn back on.
Quick Cubes
When activated, Quick Cubes reduces the
freezer temperature
to the optimum
setting for
24 hours in order to produce
more ice.
®
©
Important:
When the Quick Cubes feature is in
operation, the _
and _v_ pads for the freezer control
will not operate.
Order
R_p}ace
Reset Filter
"
"
When a water filter has been installed in the
refrigerator,
the yellow Order light will
,_'%_t_.°;_:,_I
illuminate when 90 percent of the volume of water for
which the filter is rated has passed through
the filter
OR 11 months have elapsed since the filter has been
installed.
The red Replace light will illuminate
when the rated
volume of water has passed through
the filter OR 12
months have elapsed since the filter was installed.
A
new filter should be installed immediately
when the
Replace light is illuminated.
After replacing the filter, press and hold the Reset
Filter pad for three (3) seconds.
The Order and
Replace lights will go off.
Vacation
Mode
o
The Vacation Mode feature causes the freezer to
defrost less frequently, conserving
energy. The
Vacation Mode indicator
light will illuminate when the
feature is activated.
To deactivate, press the Vacation
Mode
pad again OR open either door. The indicator
light will go out.
Notes:
• Door openings will not deactivate Vacation Mode
for approximately
one hour after activation.
• If vacationing
for more than a few days, see the
Preparing for Vacation section, page 28.
13
Tabla de contenido
