Idiomas disponibles
Idiomas disponibles
Detach the water bags from the product. Remove the product and blower before opening the stopple for draining.
Empty water in the water bags and dry them in cool place for next time's use.
Turn off the water supply, and empty water in the pool at the end.
Turn the blower (air pump) power switch to OFF.
Unplug the blower (air pump) power cord.
Loosen the hook & loop fastener and detach the inflation tube from the blower.
The product should deflate on its own within 5 minutes. Make sure the product is entirely deflated. (refer to picture L)
Remove ground support stakes.
Fold the product in half from both ends, and then fold it in half 2 more times from both sides, vertically to the first fold.
(refer to picture M, N, O)
Roll it up tightly from the end opposite the inflation tube. (refer to picture P, Q)
Slip the carry bag over the folded product and stakes (plastic balls or water bags). Zip the bag. (refer to picture R)
MAINTENANCE
Checks and maintenance of the main parts of the toys should be carried out at regular intervals, if these checks are not
carried out, the toys could overturn or otherwise become a hazard. Whenever practical, the instructions shall also be
affixed to the toy.
The seasonal inspection and maintenance should be conducted for any damage or leakage of the product.
The product can be wiped clean with a mild detergent. Keep water away from the blower (air pump) at all times.
Do not store the product when wet. Store the product and the blower indoors in dry conditions when not in use.
REPAIR
In case of any breakage of product, please patch up through hand sewing.Each type of product is provided with a repair
kit which includes six pieces of cloth(in three colors;each color has two pieces) and three 20-meter long threads of
different colors.Sewing needles are not provided and you should purchase by yourself(3# sewing needle is
suggested).
Turn off air blower and deflate the product.
Thread a needle with a spare thread and tie a knot at its end.
Close up the broken cloth and sew along the gap. Tie a knot after sewing to avoid loose thread.
In case of cloth breakage (as shown in picture S), please cover the breakage with a piece of patching cloth of proper
size. Then sew up the patching cloth along its sides. While repairing, you should take notice that the sewing should
only occur on the surface layer of the original cloth rather than reaching its underlayer.
In case of breakage in the seam position (as shown in picture T), the sewing should only occur between the two split
cloth rather than reaching the underlayer or any other cloth.
In case of large-size breakage or internal structural damage, please change product or have professionals do the
repairing.Air leakage is normal in the repaired position and air pressure of the repair product maybe lower than the
original. But it will not affect the normal use of the product.
Patching in one position for more than twice is not suggested.
Needles should be taken good care of and not be left on the product after sewing.
It is suggested that persons with sewing technique should do the repairing work.
WARNING
Failure to follow the specified instructions could result in serious injury.
Keep the product a safe distance (at least 2 m) from fire, walls and other obstructions.
The product may not be used outside in rainy and/or lightning conditions or if winds exceed 40km/h (25 MPH). Sudden
gusts of wind may lift the product off the ground.
The product must be fully inflated before any children are allowed inside. The product must stay fully inflated until
everyone is out.
If the product begins to deflate, remove all children and check for disconnection of power cord or for power outage.
Do not drag on concrete or other rough surfaces.
Unauthorized modification of the product is not allowed.
Product should be checked regularly for potentially unsafe conditions such as damaged cord, plug, housing, or parts.
12
