Idiomas disponibles
Idiomas disponibles
˜ Before use
˜ Checking viscosity
The product allows you to use spray material
with a viscosity of max. 70 DIN/sec.
Measure viscosity (Fig. H):
–
Fill the measuring cup
spray material.
–
Let the liquid run out of the measuring
cup
.
[
]
–
Measure the seconds until the spray material
stops running out of the measuring cup
The measurement result is the DIN/sec
value.
If you measure more than 70 DIN/sec:
Dilute the spray material gradually with a
suitable diluent until you measure a value
≤ 70 DIN/sec.
NOTE
Only use thinners that are suitable for the
u
respective spray material. If you use the
wrong thinner, lumps will form and clog the
product.
Never mix synthetic resin paints with
u
nitro thinner!
Read the manufacturer's instructions for the
u
respective spray material to find out about
the appropriate thinners.
Do not spray granular/body-containing
u
material.
˜ Preparing the spraying area
Cover the area around the spraying surface.
Any uncovered surfaces in the vicinity may
otherwise become contaminated.
Dry and clean the spraying surface.
If you are painting surfaces made of wood,
metal or plastic: Roughen the spraying surface,
e.g. by sanding the spraying surface with
sandpaper.
62 GB/MT
to the brim with
[
]
.
[
]
˜ Assembly
m
WARNING!
Switch off the product and disconnect
it from the mains before replacing
attachments.
˜ Removing the spray unit
Open the lock
:
[
]
–
Hold the motor unit
–
With the other hand, turn the spray unit
firmly in a counter-clockwise direction until
the spray unit disengages from the lock
(Fig. E).
Continue turning the spray unit
have aligned
[
5 ]
Pull the spray unit
[
4 ]
(Fig. C).
˜ Fastening the spray unit
Insert the connecting tube
connection
(Fig. C).
[
]
Align
with
5 ]
[
unit
clockwise until it engages in the
[
4 ]
lock
(Fig. D).
[
]
by the handle
.
[
]
[
]
[
4 ]
until you
[
4 ]
with
(Fig. D).
[
]
out of the motor unit
[
into the spray
[
6 ]
. Turn the spray
[
]
]
