Working Procedures; Before Use; Assembly; Selecting/Changing The Nozzle - Parkside PAFS 550 A1 Traducción Del Manual De Instrucciones Original

WARNING! HAZARDS CAUSED
BY MATERIALS AND SUBSTANCES!
► There is a risk of coming into contact with or
absorbing coating materials and/or cleaning
fluids . There is also a risk of inhaling vapours
from liquids . This can cause permanent dam-
age under certain conditions .
► Always wear personal protective equipment
when working on the appliance!
► Ensure sufficient technical or natural ventila-
tion .
► Follow the manufacturers' safety instructions
for the respective coating materials and
cleaning liquids .
► If you experience any symptoms, seek medi-
cal advice!

Working procedures

NOTE
► Ensure that the spray material and thinning
agent are compatible . Using an unsuitable
thinning agent may cause clots that clog the
appliance .
► To find out which thinning agent is suitable
for your spray material (water, paint thinner),
refer to the manufacturer's notes provided
with the spray material .
► Granular products and products containing
solids must not be sprayed . Their abrasive
effect will shorten the service life of the
appliance .
Preparing the spray surface
WARNING!
► Risk of electric shock due to penetrating spray
material! Be sure to mask any sockets and
switches .
♦ Cover any surfaces around the spray area ex-
tensively and thoroughly . Any surface that is
not masked could become contaminated .
♦ Make sure that the spray surface is clean, dry
and free of grease .
♦ Polished surfaces should be lightly sanded and
the sanding dust removed .
PAFS 550 A1
Spraying technique
♦ Always hold the paint spray gun at the same
distance and at a right angle to the object . The
ideal spraying distance is approx . 20–25 cm .
Move the paint spray gun evenly with your
whole arm (see fig . J) .
♦ Determine the appropriate settings in each
case by experimenting, e .g . on a piece of
cardboard .
♦ Do not switch the appliance on/off above the
spray area, but start and stop the spraying
process approx . 10 cm outside the spray area .

Before use

Assembly

NOTE
► You can assemble the appliance using two
adjustable spanners (not supplied) .
► Alternatively, you can also use a 16 mm and
19 mm wrench (not supplied) .
♦ Fit the high-pressure hose w onto the connect-
ing thread r on the appliance . Tighten the nut
using an adjustable spanner . Counter the nut
of the connection thread r with a second ad-
justable spanner (see fig . A) .
♦ Fit the other end of the high-pressure hose w
to the connecting thread of the paint spray
gun 0 . Tighten the nut using an adjustable
spanner . Counter the nut of the connection
thread of the paint spray gun with a second
adjustable spanner .

Selecting/changing the nozzle

Nozzle
Nozzle 311
Nozzle 517
♦ Insert the corresponding nozzle 5 with the
arrow tip in the spraying direction into the
nozzle chamber p .
Use
low viscosity spray material
viscous spray material
GB │ IE │ 9 ■