Specific Safety Instructions; Before Use; Connecting To A Compressed Air Source - Parkside PDRP 6.2 B2 Traducción Del Manual De Instrucciones Original

■ Keep work area clean and well lit. Cluttered or
dark areas invite accidents. This enables better
control of the compressed air cleaning gun,
especially in unexpected situations.
■ Have the compressed air cleaning gun serviced
by a qualified repair technician using only
original replacement parts. This ensures that the
safety of the compressed air cleaning gun is
maintained.
■ Keep children and bystanders away while
operating the compressed air cleaning gun.
Distractions can cause you to lose control of the
compressed air cleaning gun.
■ Dress properly. Do not wear loose clothing or
jewellery. Keep your hair, clothing and gloves
away from moving parts. Loose clothes, jewel-
lery or long hair can be caught in moving parts.
■ Wherever possible, use a condensate separator
or drain the condensate (water) from the hoses
and tubing regularly before and during the use
of the compressed air cleaning gun.
NOTE!
► An undersized compressed air system will
reduce the efficiency of your compressed air
cleaning gun.
■ Do not point the compressed air cleaning gun
at people or animals.
Specific safety instructions
■ Do not use force when operating the trigger
■ Make sure that all parts are securely mounted
before using the compressed air cleaning gun.
■ Wear the necessary protective clothing when
working with the compressed air cleaning gun,
in particular ear muffs, protective goggles and
work gloves.
│ GB │ IE
■ 6

Before use

NOTE
► The appliance may only be operated with
cleaned compressed air and may not exceed
the maximum working pressure of 6.2 bar
at the appliance. The compressor must be
fitted with a pressure reducer to regulate the
working pressure.
► Note that the maximum working pressure
may not be exceeded. An excessive working
pressure does not mean increased output;
it merely increases the air consumption and
accelerates appliance wear. Always comply
with the technical information.
► Before each use, check that there is no
condensate in the compressed air hoses.
Connecting to a compressed air
source
NOTE
► Before connecting the compressed air source,
–the correct working pressure (3–6.2 bar)
must be fully reached, and
–make sure that the trigger
actuated.
♦ Pull the supply hose connector over the quick-
release fastener on the connector nipple
it clicks into place.
.
NOTE
► To ensure that you can regulate the air
pressure, the compressed air source must be
equipped with a pressure reducer.
is not
until
PDRP 6.2 B2