Haier HLP21N Manual Del Usuario página 19

2. Thread the white end of the inlet hose by hand onto the inlet valve on the back of
the washer until firmly hand tightened.
IMPORTANT:
•
Do not connect the gray end of the inlet hose to the washer. You will damage
the threads and it will leak.
•
To avoid damage to the hose couplings, do not over tighten.
Style 1 - Using pliers, tighten the connection an additional two-thirds turn.
Style 2 - Do not use pliers to tighten the connection.
NOTE: To avoid damage to the washer inlet valve, do not use thread seal tape or
sealants on the valve threads.
Style 1
OPTION 1 - FIXED
NOTE: In order for this washer to meet the regulated energy standards, the faucet
supplying the water must be set to cold.
1. Thread the grey end of the inlet hose onto the water faucet by hand until snug.
Then using pliers, tighten an additional two-thirds turn.
IMPORTANT: To avoid damage to the hose coupling, do not overtighten.
NOTE: To avoid damage to the faucet do not use thread seal tape or sealants on
the valve threads.
2. Turn on the water faucet and check for leaks. If there is any leaking, check for
loose connections and tighten.
a
a
White End Only
Cold
a
Style 2
a
a
Gray End Only
17