Goodyear GY 2300I Manual De Instrucciones página 31

English
Owner´s manual
•
(*1): Change the oil for the first time after the first month or the first 20 working hours.
(*2): The air filter should be cleaned more frequently when the generator is used in humid or dusty environments.
Change engine oil
1. Remove the lubricant trim cover.
2. Remove the oil drain plug (1 and 2).
3. Open the lower drain screw (3 and 4).
4. Drain the oil tank through the drain hole.
5. Replace the drain plug to prevent new lubricant from leaking out.
6. Fill the tank through the pour hole. Use a funnel if necessary.
7. Check that the oil level is adequate (tank capacity 0.35L).
8. Put the plug in the pour hole.
9. Fit the cover/embellishing.
CAUTION: Please take the used oil to a clean point. Do not throw it on the ground.
WARNING: Do not drain the engine oil immediately after switching off the equipment, the engine
temperature can be very high and may cause burns.
WARNING: If you wait for the generator to cool down completely, the oil will lose its good fluidity and
will be slower and more difficult to drain. You can run the generator for a few minutes to warm up the
engine.
Maintenance of Spark Plug
Recommended spark plug E5RTC or E5TC. Spark plug gap 0.7-0.8mm.
- Remove the spark plug cap and the spark plug, clean the dirt around the spark plug hole (Image 1).
- Remove the spark plug with a spark plug wrench.
- Check that the insulator is in good condition, if not, replace the spark plug.
- If there is carbon deposits, remove them from the electrodes with a wire brush (Image 2.
- Check the distance between the spark plug electrodes, it must be between 0.7-0.8 mm; if necessary adjust
it (Image 3).
- Replace the spark plug and cap (Image 4).
1. Plug wrench
2. Spark plug cap
Image 1
NOTE: Screw in half round more after the spark plug compresses its washer if a new spark plug is used.
Screw in one-fourth round more only if the old one is used.
Image 2 Image 3 Image 4
31