Idiomas disponibles
Idiomas disponibles
English
Owner´s manual
•
Front Panel GY2300IS
1
5
6
ON/OFF button
•
I (start) position: Move the switch handle to the "run"
position to start the engine.
•
O (off ) position: The switch knob is placed in the "off"
position to turn off the generator set.
•
Place in the choke position to start the equipment cold.
Once the engine starts, return the switch to position "I"
within 5 seconds after starting.
Oil alert light (yellow)
When the oil in the crankcase drops below the safety line,
the oil protection system will automatically shut down the
engine and the oil alarm indicator will light up; The engine
can be restarted only after adding oil up to the proper oil
level.
NOTE: If the engine is stalled or cannot be started, turn the control switch to the "on" position and then
pull the starter handle.
If the oil alarm indicator flashes for a few seconds, the oil capacity is insufficient. Add oil and restart.
Overload indicator (red)
When the overload light is on or flashing, it means that
the equipment connected to the generator requires more
power than the generator can provide. It can also indicate
other problems such as the engine motor has been
over-revved, and it is shorting out.
24
2
3
4
7 8
9
1. Reset button
2. Oil alarm
3. Overload indicator
4. Operation indicator
5. Energy saving switch (ECO)
6. AC parallel interface
7. USB port
8. Ground Wire Post
9. AC outlet
