Idiomas disponibles
Idiomas disponibles
Wear a protective apron.
ATTENTION! Electric shock warning!
ATTENTION! Hot surface, risk of burns!
Only use indoors.
PLEASE NOTE! Drawings in this manual are for illustration purposes only and in some details may
differ from the actual product.
2. Usage safety
ATTENTION!
Read all safety warnings and all instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or serious injury or even death.
The terms "device" or "product" are used in the warnings and instructions to refer to:
Thermostatic water bath
2.1.
Electrical safety
a)
The plug must fit the socket. Do not modify the plug in any way. Using original plugs and matching
sockets reduces the risk of electric shock.
b)
Avoid touching earthed elements such as pipes, heaters, boilers and refrigerators. There is an
increased risk of electric shock if the earthed device is exposed to rain, comes into direct contact with
a wet surface or is operating in a damp environment. Water getting into the device increases the risk
of damage to the device and of electric shock.
c)
Do not touch the device with wet or damp hands.
d)
Use the cable only for its designated use. Never use it to carry the device or to pull the plug out of a
socket. Keep the cable away from heat sources, oil, sharp edges or moving parts. Damaged or tangled
cables increase the risk of electric shock.
e)
If using the device in a damp environment cannot be avoided, a residual current device (RCD) should
be applied. The use of an RCD reduces the risk of electric shock.
f)
Do not use the device if the power cord is damaged or shows obvious signs of wear. A damaged power
cord should be replaced by a qualified electrician or the manufacturer's service centre.
g)
To avoid electric shock, do not immerse the cord, plug or device in water or other liquids. Do not use
the device on wet surfaces.
h)
Only use grounded power sources.
2.2.
Safety in the workplace
a)
Make sure the workplace is clean and well lit. A messy or poorly lit workplace may lead to accidents.
Try to think ahead, observe what is going on and use common sense when working with the device.
b)
If you discover damage or irregular operation, immediately switch the device off and report it to a
supervisor without delay.
c)
Only the manufacturer's service point may repair the device. Do not attempt any repairs
independently!
d)
In case of fire, use a powder or carbon dioxide (CO2) fire extinguisher (one intended for use on live
electrical devices) to put it out.
e)
Children or unauthorised persons are forbidden to enter a work station. (A distraction may result in
loss of control over the device).
f)
Use the device in a well-ventilated space.
