Output Data Section In The Controller - Aventics DDL Instrucciones De Servicio

Table 16: Output module byte occupation
Byte X
No. of valves
bit 00-07
4 valves Valves
8 valves Valves
12 valves Valves
1)
4-byte mode Valves
1)
Byte X+3 cannot be used if "4-byte mode" is set, as the bus coupler only supports 24 valve solenoids.
Table 17: Assignment of the output bits
1)
Byte Applies to
X Valve
Solenoid
X+1 Valves
Solenoid
X+2 Valves
Solenoid
X+3 Output module
1)
Byte X is the start address for the output section of this module in the controller.
AVENTICS | DDL | R499050020–BDL–001–AD
7.1.4

Output data section in the controller

The DDL address determines the position of the output data in
the data range of the bus coupler, and thus the position in the
address range in the controller.
If the address 0 (automatic addressing) is set, the VS will act like
a valve unit if it only has output modules. The VS will act like a
combination module if it has input modules.
The valve system occupies 1 to 4 bytes in the output section of
the controller, depending on the set length. The output modules
occupy the last bytes (see the following table).
Byte X+1
bit 8-15
1st output module,
if available
Valves
Valves
Valves
The assignment of the output bits to the valves and solenoids
can be seen in the following table.
Bit 7 Bit 6 Bit 5
4 4 3
12 14 12
8 8 7
12 14 12
12 12 11
12 14 12
O7 O6 O5
Commissioning and Operation
Byte X+2
bit 16-23
2nd output module,
if available
1st output module,
if available
Valves
Valves
Bit 4 Bit 3 Bit 2
3 2 2
14 12 14
7 6 6
14 12 14
11 10 10
14 12 14
O4 O3 O2
89
Byte X+3
bit 24-31
3rd output module,
if available
2nd output module,
if available
1st output module,
if available
Not connected
Bit 1 Bit 0
1 1
12 14
5 5
12 14
9 9
12 14
O1 O0