Idiomas disponibles
Idiomas disponibles
Limbing (fi g. Q)
Removing the branches from a fallen tree. When limbing,
leave larger lower limbs to support the log off the ground.
Remove the small limbs in one cut. Branches under tension
should be cut from the bottom of the branch towards the top
to avoid binding the chain saw. Trim limbs from opposite side
keeping tree stem between you and saw. Never make cuts
with saw between your legs or straddle the limb to be cut.
Maintenance
Regular maintenance ensures a long effective life for the tool.
We recommend you make the following checks on a regular
basis.
Warning! Before performing any maintenance on power tools:
Switch off and disconnect the tool from the mains supply.
Oil level
The level in the reservoir should not be allowed to fall below
a quarter full.
Saw chain and guide bar (fi g. F)
After every few hours of use and before storage, remove
the guide bar (4) and the saw chain (5) and clean them
thoroughly.
Make sure that the guard is clean and free from debris.
Warning! Do not overtighten.
Oil sprocket nose via the sprocket lubriation hole, this
ensure an even distribution of wear around the guide bar
rails.
Saw chain sharpening
If you are to get the best possible performance from the tool it
is important to keep the teeth of the saw chain sharp.
Replacing worn out saw chains
Replacement saw chains are available through retailers or
BLACK+DECKER service agents. Always use genuine spare
parts.
Replacement Saw chain:
BECS2040 40cm Chain BZOC401-LA
BECS2245 45cm Chain BZOC451-LA
Saw chain sharpness
The saw chain cutters will blunt immediately if they touch the
ground or a nail while cutting.
Saw chain tension
Regularly check the saw chain tension.
What to do if your chainsaw needs repair.
Your chainsaw is manufactured in accordance with the rel-
evant safety requirements. Repairs should only be carried out
by a qualifi ed person using original spare parts otherwise this
may result in considerable danger to the user. We recommend
you keep this user manual in a safe place.
Protecting the environment
Separate collection. Products and batteries
marked with this symbol must not be disposed of
Z
with normal household waste
Products and batteries contain materials that can be recov-
ered or recycled reducing the demand for raw materials.
Please recycle electrical products and batteries according to
local provisions.
Technical data
BECS2040 AR
Type 1
wattage
W
2 000
Voltage
V
220V
ac
Bar length
cm
Max bar length
mm
Saw chain speed
m/s
(No-load)
Max cutting length
mm
Oil capacity
ml
weight (without
saw chain, guide
kg
bar, oil)
ENGLISH
BECS2040 B3
BECS2245 B3
Type 1
Type 1
1 440
1 905
120V
120V
40
40
45
459
459
511
14.5
13.5
14.5
368
368
407
170
170
170
4.1
4.1
4.3
35
