Idiomas disponibles
Idiomas disponibles
OBJ_BUCH-1543-001.book Page 19 Friday, November 18, 2011 9:16 AM
Problem
Atomisation too course
Spray jet pulsates
Spray material drips from the
nozzle
No spray material emerges from
the nozzle
After-sales Service and Customer Assistance
Our after-sales service responds to your questions concern-
ing maintenance and repair of your product as well as spare
parts. Exploded views and information on spare parts can al-
so be found under:
www.bosch-pt.com
Our customer service representatives can answer your ques-
tions concerning possible applications and adjustment of
products and accessories.
Great Britain
Robert Bosch Ltd. (B.S.C.)
P.O. Box 98
Broadwater Park
North Orbital Road
Denham
Uxbridge
UB 9 5HJ
Tel. Service: +44 (0844) 736 0109
Fax: +44 (0844) 736 0146
E-Mail: [email protected]
Bosch Power Tools
Cause
Spraying capacity too high
Air flow too low
Nozzle needle 16 soiled
Too little pressure build-up in container 10 Screw container firmly against spray gun
Spray material too viscous
Air filter 29 heavily soiled
Not enough spray material in container
Venting hole on suction tube 12 clogged
Air filter 29 heavily soiled
Spray material too viscous
Nozzle seal 17 missing or incorrectly
mounted
Deposits of spray material on nozzle needle
16 and air cap 3
Nozzle needle 16 worn
Nozzle loose
Control knob for air flow 24 not set to "maxi-
mum air flow"
No pressure build-up in container 10
Suction tube 12 loose
Nozzle needle 16 clogged
Suction tube 12 clogged
Venting hole on suction tube 12 clogged
Container seal 13 missing or damaged
Spray material too viscous
Ireland
Origo Ltd.
Unit 23 Magna Drive
Magna Business Park
City West
Dublin 24
Tel. Service: +353 (01) 4 66 67 00
Fax: +353 (01) 4 66 68 88
Australia, New Zealand and Pacific Islands
Robert Bosch Australia Pty. Ltd.
Power Tools
Locked Bag 66
Clayton South VIC 3169
Customer Contact Center
Inside Australia:
Phone: +61 (01300) 307 044
Fax: +61 (01300) 307 045
Inside New Zealand:
Phone: +64 (0800) 543 353
Fax: +64 (0800) 428 570
Outside AU and NZ:
Phone: +61 (03) 9541 5555
www.bosch.com.au
English | 19
Corrective Measure
Turn thumbwheel 7 in direction I
Turn control knob 24 toward the right
Clean nozzle needle
Dilute the spray material again and carry out
a test-spray run
Change the air filter
Refill spray material
Clean suction tube and hole
Change the air filter
Dilute the spray material again and carry out
a test-spray run
Mount nozzle seal into spray gun (groove
must face away from the spray gun)
Clean nozzle needle and air cap
Replace nozzle needle
Tighten union nut 5
Set control knob for air flow 24 to "maximum
air flow"
Screw container firmly against spray gun
Insert suction tube properly
Clean nozzle needle
Clean suction tube
Clean suction tube and hole
Slide (new) container seal over suction tube
Dilute the spray material again and carry out
a test-spray run
1 619 929 K18 | (18.11.11)
