Idiomas disponibles
Idiomas disponibles
CAM80CM
If you would like to attach the camera with threaded screws fitted through the
construction (fig. c, page 6)
A
NOTICE! Risk of damage!
Ensure that that nuts cannot be pulled through the body shell when they are tightened.
Use larger washers or metal plates if necessary.
➤ Drill Ø 4.5 mm holes at the points you have just marked.
➤ Deburr all drill holes and apply rust-protection.
➤ Screw the camera bracket on with the M5 x 20 mm threaded screws.
Depending on the thickness of the construction, you may require longer threaded screws.
Creating a through-hole for the camera connection cable (fig. d, page 6)
I
NOTE
If possible, use available openings – such as ventilation grilles – to feed the connection
cables through. If there are no existing openings, you must drill a hole with a
16 mm diameter.
A
NOTICE! Risk of damage!
Ensure that there is sufficient space on the other side for the drill head to come out
➤ Drill a hole of Ø 16 mm near the camera.
➤ Deburr all drill holes that have been made in the sheet metal and apply rust-protection.
➤ Place cable sleeves in all sharp edged ducts.
Mounting the camera
A
NOTICE! Risk of damage!
Only use the screws supplied to mount the camera in the camera bracket. Longer
screws will damage the camera.
➤ Push the camera into the camera bracket.
➤ Attach the camera loosely with the two screws M3 x 8 mm in the slots (fig. e, page 6).
➤ Align the camera provisorily so that the lens is at an angle of approx. 50° to the perpendicular
axis of the vehicle (fig. f, page 7).
A
NOTICE! Risk of damage!
Never mount the camera without the camera guard.
EN
Mounting the camera
17
