Idiomas disponibles
Idiomas disponibles
3. Assembly: Insert the attachment tool
into the collet chuck (2).
Disassembly: Pull the attachment
tool out of the collet (2).
4. Tighten the clamping nut (1).
Charging the battery
See also the charger instruction manual.
Notes
• If warm, allow the battery to cool be-
fore charging.
• Do not expose the battery to direct sun-
light for long periods and do not place
it on a radiator (max. 50°C).
Charging the battery
1. Remove the battery (18) from the
device.
2. Push the battery (18) into the charging
slot of the battery charger (20).
3. Connect the battery charger (20) to a
power outlet.
4. After charging, disconnect the battery
charger (20) from the mains.
5. Pull the battery (18) out of the battery
charger (20).
Checking the battery charge
level
LEDs
red, orange, green Battery charged
red, orange
red
When the device
is on, the battery
status indicator (7)
displays the battery
charge level.
Meaning
Battery partially
charged
Battery needs to be
charged
Operation
Working instructions
WARNING! Risk of injury! If pos-
•
sible, use clamps to hold the workpiece
in place. Never hold a small workpiece
in one hand and the device in the other
while using the device.
DANGER! Risk of injury! Ensure
•
that you have sufficient space in which
to work, and that you do not endanger
other people.
• Adjust the guard cover such that any
sparks or detached parts cannot hit
either the user or any bystanders.
The guard cover must also be posi-
tioned such that the sparks cannot ig-
nite combustible parts, including those
in the surroundings.
• The attachment tool must not be used
with a cutting stand.
• Only switch on the device when the at-
tachment tool is not touching the work-
piece.
• Excessive pressure reduces the perform-
ance of the power tool and leads to
faster wear of the attachment tool.
• Always work in the counter-direction.
This ensures that the device is not
pushed out of the cut through lack of
control.
The direction of rotation arrow (11)
symbolises the running direction of the
attachment tool.
• After a heavy load, let the device idle
for a few minutes to cool down the at-
tachment tool.
• Do not touch the attachment tool until it
has cooled down.
Cutting
Requirements
• Cutting disc (diameter ≤ 38 mm)
GB
MT
41
