Idiomas disponibles
Idiomas disponibles
24 Mandrel (cutting and grinding discs)
25 Milling pin
26 Milling cutter pin
27 Spiral milling pin
28 Circle cutter
29 Cutting disc
30 Plastic brush
31 Polishing sander
32 Felt polishing disc (large)
33 Felt polishing disc (small)
34 Cutting disc (small)
35 Grinding disc
36 Sandpaper
37 Corundum mounted point
38 Silicon carbide mounted point
39 Mandrel (abrasive belt)
40 Grinding belt
41 Polishing compound
42 Mounting key
Fig. B
43 Clamping screw
44 Screw
Description of functions
The device enables clean sanding/grind-
ing, cutting, polishing, brushing, engraving
and drilling.
Please refer to the descriptions below for
information on how the operating ele-
ments work.
Technical data
Cordless Rotary Tool
............................... PPFBSA 12 A1
Rated voltage U ....12 V ⎓ (direct current)
Rated speed n ............ 5000-32000 min
Weight with battery (12 V, 2 Ah)
.......................................................≈0.58 kg
Tool holder ...............................≤⌀ 3,2 mm
Sound pressure level (L
..........................................73.2 dB; K=3 dB
Sound power level (L
– Measured ....................84.2 dB; K=3 dB
Vibration (a
) .....1.130 m/s²; K=1.5 m/s²
h
Battery ................................................. Li-Ion
Temperature ................................... ≤50 °C
– Charging ................................4 – 40 °C
– Operation ...........................-20 – 50 °C
– Storage .................................. 0 – 45 °C
Levels of noise and vibration were determ-
ined according to the standards and regu-
lations in the declaration of conformity.
The specified total vibration value and the
stated noise emission value have been
measured according to a standardised
test method and can be used to compare
one power tool with another. The specified
total vibration value and the stated spe-
cified noise emission value can also be
used for a provisional assessment of the
load.
WARNING! The vibration and noise
emissions may deviate from the specified
values during actual use of the power tool,
depending on how the power tool is be-
ing used. Try to keep the exposure to vi-
brations as low as possible. An example
of a measure to reduce vibration exposure
is limiting the working hours. All parts of
the operating cycle have to be considered
while doing so (for example, times when
the power tool is switched off and times
when it is switched on but running without
any load).
WARNING! Grinding thin metal
sheet or other well vibrating structures
with a large surface area can result in
−1
increased noise exposure and a much
(up to 15 dB) higher overall noise emis-
sion than the specified noise emission val-
ues. Use heavy flexible damping mats or
similar to prevent sound radiation from
GB
MT
)
pA
) ............................
WA
29
