Idiomas disponibles
Idiomas disponibles
Front Panel Controls and Their Functions
®
TEAC
@ Power standby/on button
When the main power switch is ON :
Press standby/on button to turn the power on.
Press it again to turn the system off (power
standby mode).
The indicator lights up in power standby
mode and goes out when this unit is turned
on.
@Power standby indicator
This indicator lights up in the power standby
mode and goes out when this unit is turned
on,
@Remote control signal sensor
This sensor receives the signal from the
remote control transmitter.
ORecord selector
Set this selector to the appropriate position
before beginning recording.
source:
Set the selector to this position to record the
radio broadcast, CD, record or auxiliary
source,
off:
Set to this position when you do not record.
tape 1>2/MD:
Set to this position to record from the
cassette deck 1 to 2 or MD recorder.
MD/tape
2> 1:
Set to this position to record from the MD
player or cassette deck 2to 1.
Volume control
This control is used for adjusting the signal
output level to the speakers.
Oinput selector
Rotate this selector to select the desired
input source.
MD/tape 2:
For listening to the sound from the unit
connected to the MD/TAPE 2 jacks on the
rear panel.
tape 1:
For listening to tape.
cD:
For listening to CD.
tuner:
For listening to radio broadcast.
phono:
For listening to record.
aux:
For listening to the sound from the unit
connected to the AUX jacks on the rear
panel.
OCD direct indicator
This indicator will light up when the CD
direct function is engaged.
OCD direct button
Press this button for the pure sound when
you listen to the CD, and then the tone and
balance controls are bypassed. Press it
again to resume the controls.
Note:
When the CD direct function is engaged, no
signal is output to the TAPE REC outputs.
Therefore, when recording, set the CD direct
button to OFF (the indicator above the button
is unlit).
OrTreble control
This control is used for adjusting the level of
the high frequency sound range.
@Bass control
This control is used for adjusting the level of
the low frequency sound range.
@Balance control
This control is used for adjusting the
balance of the volume level between the left
and right channels.
@deadphones jack (phones)
Connect the headphones plug to this jack for
listening through headphones.
Sound from the speakers will not be heard
when headphones are connected to this
jack.
Note:
Decrease the Volume level to minimum
(ccposition) before connecting headphones.
@® Main power switch
Press the power button to ON.
Press it again to turn the system off.
Note:
Leave this main power switch ON at all
times.
