cecotec DRUMFIT X-BIKE 3000 NEO Manual De Instrucciones página 52

ENGLISH
6. TROUBLESHOOTING
Problem
The exercise bike is unstable.
Unstable handlebar.
No pedalling resistance.
7. CLEANING AND MAINTENANCE
Note:
The frequency of cleaning and maintenance indicated is a guideline. It will depend on the
frequency and intensity of the user.
Examine the equipment periodically in order to detect any issue, such as loose bolts.
-
Lubricate the moving parts periodically to prevent premature wear.
-
Inspect and tighten all parts before using the machine. Replace any defective parts
-
immediately, and do not use the machine again until it is in perfect working condition.
The machine can be cleaned using a slightly damp cloth and mild non-abrasive detergent.
-
Do not use solvents.
Do not try to repair the machine by yourself. Should you have any difficulty with the
-
assembly or operation of the exercise bike, or if you think that any part is missing, contact
the official Cecotec Technical Support Service.
You must check the screw condition every two or three weeks.
-
If cranks get loose:
-
52 DRUMFIT X-BIKE 3000 NEO
Possible cause
The ground is not flat
or there is an object
under the rear or front
stabiliser.
The rear stabiliser wasn't
properly adjusted.
The screws are loose.
Magnetic-resistance
range problem.
The resistance knob is
damaged.
Flywheel problem.
Damaged bearings.
Possible solution
Relocate the machine
and/or remove the object
underneath the stabiliser(s).
Adjust the rear stabiliser.
Tighten the screws.
Contact the official Cecotec
Technical Support Service.
Contact the official Cecotec
Technical Support Service.
Contact the official Cecotec
Technical Support Service.
Contact the official Cecotec
Technical Support Service.