Hama EWS-Trio Instrucciones De Uso página 8

Warning – Batteries
• When inserting batteries, note the correct polarity (+ and
- markings) and insert the batteries accordingly. Failure to
do so could result in the batteries leaking or exploding.
• Only use batteries that match the speci ed type. Keep the
instructions for the correct choice of batteries included with
the operating instructions of devices safe for future reference.
• Before you insert the batteries, clean the battery contacts
and the polarity contacts.
• Do not allow children to change batteries without supervision.
• Replace all the batteries in a set at the same time.
• Do not mix old and new batteries, or batteries of different
types or from different manufacturers.
• Remove the batteries from products that are not being used
for an extended period (unless these are being kept ready
for an emergency).
• Do not short-circuit batteries.
• Do not charge batteries.
• Do not burn batteries or heat them up.
• Never open, damage or swallow batteries or allow
them to enter the environment. They can contain toxic,
environmentally harmful heavy metals.
• Remove spent batteries from the product and dispose of
them without delay.
• Avoid storing, charging and using in extreme temperatures
and at extremely low atmospheric pressures
(such as at high altitudes).
• Ensure that batteries with damaged housings
do not come into contact with water.
• Keep batteries out of the reach of children.
4. Getting started
Note
Before use, make sure that you insert the batteries in the
measuring station rst and then in the base station.
5. Installation
Note – Installation
• We recommend initially placing the base station and
measuring station(s) in the intended locations without installing
them and making all the settings described in 6. Operation.
• Only install the stations once the appropriate settings have
been made and a stable wireless connection is established.
8
Note
• The wireless transmission range between the measuring
and base stations is up to 50 m in open spaces.
• Before installation, ensure that wireless transmission
will not be disrupted by interference or obstacles like
buildings, trees, vehicles, high-voltage lines, etc.
• Before the nal installation, ensure that there is su cient
reception between the intended installation locations.
• When installing the measuring station, ensure that it is
protected from direct sunlight and rain.
• The international standard height for measuring air
temperature is 1.25 m (4 ft) above ground.
Warning
• Buy special or suitable installation material from a
specialised dealer for wall-mounting.
• Ensure that no faulty or damaged parts are installed.
• Never apply force during installation. This could damage
the product.
• Before installation, ensure that the chosen wall is
suitable for the weight to be mounted, and make sure
that there are no electrical wires, water, gas or other
lines at the installation site on the wall.
• Do not mount the product above locations where
persons might linger.
• We recommend installing the measuring station securely
on an outdoor wall using the opening (19).
6. Operation
6.1 Connection to the measuring station
After you have inserted the batteries, the base station
automatically searches for a connection to the three
measuring stations and performs initial setup.
Note
• Remember that each of the three measuring stations
must use a different channel.
• Initial setup takes approximately 3 minutes.
• During the connection attempt, the measuring station
radio symbol will ash.