Idiomas disponibles
Idiomas disponibles
Trouble or fault
Automatic leveling doesn't
work.
Laser receiver not receiving a
laser beam
The reception range is too
short
10
Disposal
WARNING
Risk of injury due to incorrect disposal! Health hazards due to escaping gases or liquids.
▶ DO NOT send batteries through the mail!
▶ Cover the terminals with a non-conductive material (such as electrical tape) to prevent short circuiting.
▶ Dispose of your battery out of the reach of children.
▶ Dispose of the battery at your Hilti Store, or consult your local governmental garbage disposal or public
health and safety resources for disposal instructions.
Most of the materials from which Hilti products are manufactured can be recycled. The materials must be
correctly separated before they can be recycled. In many countries, your old tools, machines or appliances
can be returned to Hilti for recycling. Ask Hilti Service or your Hilti sales representative for further information.
▶ Do not dispose of power tools, electronic equipment or batteries as household waste!
11
Manufacturer's warranty
▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
12
FCC statement (applicable in US)/IC statement (applicable in Canada)
This equipment has been tested and found to comply with the limits for a class B digital device,
pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by taking the following
measures:
•
Re-orient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment to a power outlet on a circuit different from that to which the receiver is
connected.
•
Consult the dealer or an experienced TV/radio technician for assistance.
This device is in compliance with paragraph 15 of the FCC Regulations and RSS-210 of the ISED Regulations.
Operation is subject to the following two conditions:
*2328447*
Possible cause
Selector switch in the
The inclination sensor is faulty.
The laser is not in receiver mode
The laser receiver is too far away
from the combilaser.
Working in weak area of the laser.
Lighting conditions on site are too
bright
Light is shining directly into the
detection area.
2328447
Action to be taken
▶ Set the selector switch to the
position.
position.
▶ Contact Hilti Service.
▶ Activate the receiver mode on
the combilaser.
▶ Position the laser receiver closer
to the combilaser.
▶ Work in the more effective area
of the laser (front).
▶ Position the combilaser and /
or the laser receiver in an area
where the light is dimmer.
▶ Prevent light from shining
directly into the detection area,
for example by shading it.
English
41
