TESY 2512 Manual página 6

Thermoregulator adjustment
Power switch and thermoregulator should be set to
maximum position until the desired room temperature
is reached. Then turn thermoregulator switch in the
opposite direction till red light indicator goes down.
Thermoregulator may stay in that position after that.
Immediately after room temperature falls below
thermoregulator value thermal switches are turned on
automatically until set temperature is reached. In that
way room temperature is steady with minimum energy consumption.
If you want to prevent temperature fall in the room
below 0 degrees Centigrade adjust thermostat switch in
its initial position and turn on the two power buttons.
24-hours timer models ("T")
Adjust the heating period in the following consequence:
•
Set the clock to the correct
time. If it is 10 o'clock turn the
figures dial so that the mark is
positioned to the figure of 10.
Turn the figures dial only in the direction indicated
with arrows! Adjust the period of operation of the
appliance by pushing black keys to the center – every one
of them corresponds to 15 minutes period. Sector of the
pushed keys will correspond to the period of operation of
the radiator in automatic mode every day.
Important : Plug should always be connected to the
socket outlet!
•
In order to change programmable period of
automatic operation turn black keys backwards and
adjust new periods of operation.
•
If you do not want the appliance to operate in
programmable mode push all black keys to the
center of the figures dial. To turn off the radiator in
that case you have to pull the plug out of the socket.
In that way unnecessary operation of the timer is
avoided.
Thermal fan models ("V")
Models equipped with a 500W thermal fan offer
faster achievement of desired temperature and better
ventilation in the room. Thermal fan may function
separately or together with oil-filled radiator. Thermal
fan is positioned in the bottom part of the front panel
of the radiator and is turned on by a switch positioned
in that part of the panel. Cold air is sucked through the
grating in the front part of the front panel and hot air is
released in the room through the grating positioned in
the bottom side part of the radiator panel. Desired room
English
temperature with thermal fan operation is adjusted by
thermoregulator of the radiator in the above mentioned
manner. For the normal operation of the thermal fan
it is necessary that air passes unobstructedly through
inlet and outlet grating. Electrical device is intended
for domestic use in premises with low level of dust
pollution. Dust is accumulated after certain period
of operation. In is necessary to check periodically
level of pollution and if needed to consult the service
organization for cleaning.
In case of obstruction of grating of incoming and
outgoing air thermal protection is enabled. It turns
off heater of the thermal fan. In that case disconnect
radiator from the socket outlet, eliminate the cause of the
obstruction, wait about 5 minutes and turn on the radiator
again. If the thermal fan does not operate connect
authorized service at your location.
Minimum distance between hot air outlet of the thermal
fan and furniture (or other objects) should be 60 cm.
We recommend when desired room temperature is
achieved to turn off thermal fan and to operate the
appliance only in "radiator mode".
ON/OFF
MAINTENANCE
In order to provide long period of operation your
oil-filled radiator does not need any kind of special
maintenance. Clean radiator with a damp soft cloth. Do
not use solvents or abrasive detergents. If necessary use
a vacuum cleaner to clean the dust from the radiator!
Warning: in order to avoid overheating
do not cover the appliance!
Instructions for environmental protection
Obsolete electric devices contain valuable materials
and therefore they should not be treated as domestic
waste! We ask you for cooperation with your active
behavior for the protection of resources and nature.
We ask you to return your appliance at the organized
buy-back stations (if there are any).
Usage and Storage Instructions
EN
5