Idiomas disponibles
Idiomas disponibles
GB MT
Recharging the battery
If warm, allow the battery to cool
before charging.
Charge the battery (1) when only
the red LED on the level indicator is
illuminated.
The battery's (1) charge level is indi-
cated by the charge state indicator.
1. Remove the battery (1) from the appli-
ance if necessary.
2. Plug the battery charger (3) into a
mains outlet.
3. Insert the battery (1) in the charging
compartment of the battery charger (3).
4. Pull the battery (1) out of the battery
charger (3).
5. Unplug the battery charger (3) from the
mains.
Overview of the LED indicators on
the charger (3):
Green LED (5) lights up without
battery inserted: Charger ready.
Green LED (5) lights up: Battery
such alleged charged.
Red LED (4) lights up: Battery
charging.
Red (4) and green (5) LEDs flash: Error
Used batteries
• If a fully recharged battery lasts for
considerably shorter operating times,
the battery is used up and needs to be
replaced. Only use an original replace-
ment battery from the (Parkside) X 12 V
Team series, which can be purchased
22
from the online shop (see the "Spare
parts" section).
• Always take heed of the applicable safe-
ty instructions as well as the environmen-
tal protection regulations and information
(see "Cleaning and Maintenance").
Storage
• Remove the battery before storing the
unit for longer periods of time.
• During a longer storage period, check
the state of charge of the battery and
recharge if necessary roughly every 3
months.
• The storage temperature for the battery
is between 0 °C and 45 °C. Avoid ex-
treme cold or heat during storage to en-
sure the battery output is not adversely
affected.
• Only store the batteries in the partially-
charged state. During prolonged stor-
age, 2 to 3 LEDs should be illuminated.
The battery charge status indicator of
the cordless tool signalises the state of
charge of the battery (1).
Wall mounted charger
(optional)
You can also mount the charger (3) on
the wall.
• Using dowels, place two screws 54 mm
apart at the desired position of a wall.
• The screw head can have a diameter
of 7 - 9 mm
• Leave the screw heads protruding at a
distance of approx. 10 mm from the
wall.
• With the openings of the wall bracket,
you can attach the charger (3) to the
two screws and pull the charger down
until it stops.
