Idiomas disponibles
Idiomas disponibles
HARNESS
Instructions for Use
GB
EU DECLARATION OF CONFORMITY
SpanSet UK Limited, Telford Way, Middlewich, Cheshire,
CW10 0HX, United Kingdom.
Declares that – SpanSet Harnesses model(s):
1-X, 2-X, 1-XR*, 2-XR*, Driver*, Mewp-Pro, Scaff Pro,
Spectre, Spectre 2
Have been subject to an EU Type-Examination in
accordance with Module B of the PPE Regulation (EU)
2016/425 and has been shown to satisfy the relevant
requirements of Annex II of this Regulation as a category
III product through:
1. Examination of the relevant technical documentation
2. Testing to the following standard(s): EN361:2002,
EN1497:2007*
The product is identical to the PPE which is the subject of
an EC Type-Examination
Certificate No.
2777/12578-02 (1-X, 2-X),
2777/14097-01 (Driver),
2777/13773-01 (Mewp-Pro)
2777/14245-01 (Scaff Pro)
issued by SATRA Europe, Republic of Ireland (Notified
Body No. 2777)
The product is identical to the PPE which is the subject of
an EC Type-Examination Certificate No.
719730* (1-XR, 2-XR)
715763 (Spectre, Spectre 2)
issued by BSI Group, The Netherlands (Notified Body No.
2797)
The product is subject to the procedures set out in
Module D of the PPE Regulation (EU) 2016/425 under the
supervision of: BSI Group, The Netherlands (Notified Body
No. 2797).
UK DECLARATION OF CONFORMITY
SpanSet UK Limited, Telford Way, Middlewich, Cheshire,
CW10 0HX, United Kingdom.
Declares that – SpanSet Harnesses model(s):
1-X, 2-X, 1-XR*, 2-XR*, Driver*, Mewp-Pro, Scaff Pro,
Spectre, Spectre 2
Have been subject to an UKCA Type-Examination in
accordance with Module B of the PPE Regulation (EU)
2016/425 as brought into UK Law and amended and has
been shown to satisfy the relevant requirements of Annex
II of this Regulation as a category III product through:
1. Examination of the relevant technical documentation
2. Testing to the following standard(s): EN361:2002,
EN1497:2007*
The product is identical to the PPE which is the subject of
an EC Type-Examination
Certificate No.
AB0321/17671 (1-X, 2-X),
AB0321/18199 (Driver),
AB0321/17668 (Mewp-Pro)
AB0321/18198 (Scaff Pro)
issued by SATRA Europe, Republic of Ireland (Notified
Body No. 2777)
The product is identical to the PPE which is the subject
of an EC Type-Examination Certificate No. 749881 (1-
XR, 2-XR, Spectre, Spectre 2) issued by BSI Group, The
Netherlands (Notified Body No. 2797)
The product is subject to the procedures set out in Module
D of the PPE Regulation (EU) 2016/425 (as brought into UK
law and amended) under the supervision of: BSI Group,
Kitemark Court, Davy Avenue, Knowhill, Milton Keynes,
MK5 8PP
INSTRUCTIONS
The textile components of the product are produced from
Polyester & Nylon. It is essential that this product is sold to
the end-user with the instructions in the correct language
of the country in which the product is to be used.
SpanSet recommends that where possible all PPE
be personal issue.
A full body harness is the only acceptable body holding
device that can be used in a fall arrest system.
It is essential that this product is sold to the end user with
the instructions in the correct language of the country in
which the product is to be used.
This harness is for use in a fall arrest system that has had
a thorough risk-assessment including an analysis of the
clearance necessary below the user to ensure safety.
Always thoroughly inspect all equipment and components
before and after fitting, pay particular attention to the
operation of buckles and connectors.
If the harness is to be used for fall arrest, only use with a
CE approved fall arrest system.
To connect a system together, refer to the user instructions
for each individual part.
Ensure that all equipment and components used within the
fall arrest system are compatible.
Any karabiner, or connector used must comply with EN
362, and be securely locked to prevent opening.
Only connect steel chest and dorsal attachment points
(indicated by a letter 'A' symbol) to fall arrest or work
positioning systems.
Any anchorage point used should meet the requirements of
EN795 (12kN). We recommend that all persons using fall-
arrest equipment should take care to follow best practice
