Inspection, Maintenance, Repair And End Of Use - Spanset Magnum-X Serie Borrador De Las Instrucciones

or even off the load during the lifting process. Make sure the lifting strap
does not twist or intersect with the load. Use adequate edge protection
for coarse and/or sharp-edged loads. Make sure that the part of the load
to be fastened to the sling can take the force introduced during lifting.

4 Inspection, maintenance, repair and end of use

Magnum-X round slings must be checked for defects before each
use. If you detect defects, the Magnum-X round slings must be set
aside. An authorized person must perform the check according to the
employer's specified inspection interval, but at least once per year.
Depending on the usage and operational conditions, interim inspec-
tions may also be necessary. The inspections must be documented
according to BGR 500. Additionally, all metallic fittings must undergo
crack inspection at least once every three years. The inspection must
be done according to EN 10228 Part 1 (Magnetic powder testing -
"fluxes") or Part 2 (Penetration Test).
Magnum-X smart
a signal colour. If the external tube sleeve is damaged, it can easily be
changed by the manufacturer or another authorized person. The inter-
nal tube sleeve's signal colour makes it easier to notice the damage.
Speed up and simplify documentation of sling inspections. With
IDXpert
®
can find more information at our homepage: www.spanset.de.
Magnum-X round slings can be repaired, for example, if:
- the label is missing and the manufacturer is unknown,
- only the tube sleeve
Repairs can be made only by the manufacturer or a manufacturer-
authorized person.
1
4
Page
EN
5
18
Magnum-X product line have one.
round slings have a second, interior tube sleeve in
2
, SpanSet offers the right software and hardware. You
is damaged.
3
secutex, NoCut
®
The Magnum-X smart is made with a side seam.
The Magnum-X smart is equipped with two tube sleeves, while other round slings in the
1