Home Decorators Collection MAKENNA 56235 Guía De Uso Y Mantenimiento página 12

Preparing the Remote Control
Preparing the remote control
NOTE: The remote control has already been paired to the ceiling
fan for your convenience. If you have two of the same model fans
in your home, please follow the steps below to control each fan
independently.
NOTE: The remote control battery will weaken with age and
should be replaced before leaking takes place, as this will damage
the remote control. Dispose of used battery properly and keep the
battery out of the reach of children.
NOTE: The switch marked "D/O" controls the dimming function
of the lights. If you wish to use the dimming function or
Hubspace app, keep the switch in the "D" position. To disable the
dimming function, set the switch to the "O" position.
□
Confirm that the power to the fan is off at either the wall switch or
breaker box.
□
Remove the battery cover by pressing firmly on the arrow and
sliding the cover off.
□
Install two 1.5V AAA batteries (M).
□
Return power to the fan at the wall switch or breaker box.
□
If the remote control doesn't work as normal, press then release
the "Learn" button for 1-2 seconds (located in the remote's battery
compartment) within 30 seconds of turning on the power.
□
If pairing is successful, the fan's light kit will flash and the blades
will begin to spin.
□
Replace the battery cover on the remote control.
1 to 3 mode
□
To use more than one remote control for your fan, press the "Learn"
button for 10 seconds and release within 30 seconds of turning on the
power. Once pairing is successful, the fan's light kit will flash and the
blades will begin to spin.
□
Repeat the above process for the remote controls you want to work
with this fan.
□
The fan can be only controlled by 3 remote controls maximum at the
same time after "Learning". If you use a fourth remote control to handle
the fan, the first remote control will be replaced.
1 to 1 mode
□
To use only one remote control for your fan, press and release the
"Learn" button for 1-2 seconds within 30 seconds of turning on the
power. The "1 to 3" mode will be cleared and returned back to "1 to
1" mode.
12
LEARN
K7
M