Saeco MEGACOLD L Instrucciones De Uso página 78

28
Command 60 Erases the memory:
In response to this command the screen displays Code 0000. Enter the figure 6203 then press the ENTER
key to cancel al the data stored in the vending machine's memory. The procedure to cancel the data from the
memory is as follows:
•
Programming mode, ............................................................................. Command 0 appears on the display
•
Type 60 and press ENTER, .................................................................. Code 0000 appears on the display
•
Type 6203 and press ENTER, .................................................... 'memory cleared' appears on the display
Note: To exit from the command press the button on the VMC board once.
Command 61 Reset security/access code:
This command makes it possible to reset the access code used in the EVA_DTS protocol.
E
Command 62 Enable discount:
N
The following discount types can be enabled depending on the value set in this parameter:
G
0 = no type of discount.
L
1 = discount for different time slots.
I
2 = discount for purchases with key /credit card (only possible in MDB mode).
S
3 = discount for time slots and for purchases with key /credit card (only possible in MDB mode).
H
N.B. Enter the values of the desired time slots in daily timer 2 in order to enable the application of the
discount.
For machines with the cashless system this command makes it possible to apply different price tables. The
selection of the table to be applied at the time of sale occurs automatically through the communication
protocol between machine and reader (only possible for MDB cashless systems which are provided with this
option).
Command 63 Set the mono/multivend:
If the command is set at 0, the default value, the vending machine operates in monovend mode, and in cash
mode the surplus credit is returned. If this is not possible the sum is added to the amount totalled due to
overpricing. Vice versa, if the command is set at 1, the vending machine operates in multivend mode, and the
amount which exceeds the cost, after the sale, is displayed once again and can be recovered by simply
pressing the coin return button or used for a new selection.
Next you have the option of selecting whether or not to keep the overpay at the user's disposal for an
indefinite period of time. 1= function enabled , 0 = function disabled.
Command 64 Sets the message display language:
This command controls the language in which the messages are displayed. Value 0 corresponds to Italian,
value 1 to English, value 2 to French, value 3 to German, value 4 to Dutch, value 5 to Swedish, value 6 to
Finnish and value 7 to Spanish 8 to Portuguese 9 to Danish 10 to Norwegian.
Commands 66-67 Internal temperature and evaporator temperature display:
The value set at these commands determines the information shown on the second line of the display (see
table). As default, the clock is displayed.
Command 66
0
1
0
1
* Command 66 displays the internal temperature of of the SLAVE machine connected to the master machine.
In this case the temperature of the master is indicated by TM, whereas the temperature of the slave is
indicated by TA and TB respectively.
Furthermore, only during the programming phase, command 67 displays the internal temperature and the
evaporator temperature of the SLAVE machine if connected.
Activation of this command cancels all the data programmed by the user and the
new default parameters determined by the manufacturer are automatically set.
Command 67 Displayed value
0 Displays clock
0 Displays internal temperature *
1 Displays internal temperature + evaporator temperature
1 Displays clock + internal temperature
MEGACOLD L – Issue 01