Warnings For The Installation; Payment System Connection; Warnings For The Demolition Of The Machine - Saeco MEGACOLD L Instrucciones De Uso

16
•
To switch on the machine, follow the instructions below. To connect the wiring cable. If the message
"MEMORY CLEARED" appears on the display, press the button on the main board inside the box of the
E
coin dispensing mechanism to initialize the memory. The message "DOOR OPEN" appears on the
N
display. The vending machine will automatically start a self-test. If no errors are identified, the machine is
G
ready to use.
L
•
To apply the product labels, see point 5, fig. 1, remove the coin mechanism support fixed by the means
I
of the screws and put them into the provided pocket.
S
•
Programme the machine (see chap. "PROGRAMMING"), set the REFRIGERATOR PARAMETERS (see
H
relative paragraph) according to the foodstuffs placed in the vending machine and set the prices.
•
If the machine is supplied with change-giving mechanism, insert the corresponding coins in the change-
giving tubes.
•
Load the machine with products (see paragraph Loading the products).
6.4

WARNINGS FOR THE INSTALLATION

The machine is sold without payment system. Therefore whatever default to the machine or damages to
person or things due to an incorrect installation, use or similar caused by the payment system will be only and
exlusively charged to those who have carried out the installation of the machine.
6.5

PAYMENT SYSTEM CONNECTION

The coin mechanism must be connected and disconnected
with the machine switched off.
The connectors required to connect the coin mechanism are
located next to the main board. The vending machine is set up for
payment systems with EXECUTIVE, MDB and BDV protocols.
•
Fasten the coin mechanism on the support between the two
pins.
•
Connect the coin mechanism connectors to the machine.
•
Adjust the coin chute on the coin mechanism opening
•
Adjust the coin return button leverage
If the machine is disassembled in order to be definitively demolished, it is obligatory to follow the rules in force
regarding the protection of the environment.
All ferrous, plastic or similar materials should be taken to the authorized depots.
Particular care should be given to:
7

WARNINGS FOR THE DEMOLITION OF THE MACHINE

MASTER / SLAVE CONNECTION
A slave vending machine can be connected to the MASTER
machine. A serial wire is used and the connector is
accessible from the back of the machine.
It is also be possible to connect a Stand-Alone in Slave
mode, see command 58.
MEGACOLD L – Issue 01