9. RADIO RECEIVER
- Max. number of radio transmitters stored:
- Frequency:
- Security:
- Number of combinations:
if necessary, use an external antenna for
433 MHz. Connect the antenna to the an-
tenna terminals using RG58 coaxial cable.
In case of standard installations where no advanced functions are required, it is possible to proceed to manual
storage of the transmitters, making reference to the standard programming described on TABLE A.
1) If you wish the transmitter to activate output 1, press pushbutton PR1 on the receiver installed on the control
board, otherwise if you wish the transmitter to activate output 2, press pushbutton PR2.
2) When LED DL1 starts blinking, press "hidden key" on the transmitter, LED DL1 will remain continuously lit.
3) Press the key of the transmitter to be memorized, LED DL1 will fl ash quickly to indicate that it has been
memorized successfully. Normal fl ashing will then be resumed.
4) To memorize another transmitter, repeat steps 2) and 3).
5) To exit programming mode, wait for the LED to go off completely or press the key of a remote control that
has just been memorised.
This mode is used to copy the keys of a transmitter already stored in the receiver memory, without acces-
sing the receiver. The procedure must be done inside the receiving zone.
The fi rst transmitter must be memorised in manual mode (see paragraph 9.4).
1) Press ""hidden key"" on the transmitter already memorised.
2) Press key T on the transmitter already memorised, which is also to be attributed to the new transmitter.
3) Within 10 s., press "hidden key" on the new transmitter to be memorised.
4) Press key T to be attributed to the new transmitter.
5) To memorise another transmitter, repeat the procedure from step (3) within a maximum time of 10
seconds. After 10 seconds the receiver exits the programming mode.
6) To copy another key, repeat from step (1), after waiting for the receiver to exit the programming mode
(or after disconnecting the receiver from the power supply).
10. WARNING
It is recommended that the installation includes all the accessories necessary to ensure operation according to current provisions,
always using genuine devices.
This equipment must be installed and used in strict compliance with the manufacturer's instructions. The manufacturer cannot be
held responsible for any damage deriving from improper or unreasonable use.
The manifacturer is not responsable for any inaccuracies contained in this booklet and reserves the right to make changes at any
time without any prior notice whatsoever.
24 -
CSB-BR
9.1 RECEIVER SPECIFICATIONS
9.2 RADIO CHANNEL FUNCTIONALITY
Channel 1:
START command
Channel 2:
Activates the relay contact on the terminal block J4 "2nd CH RX"
9.3 RADIO ANTENNA INSTALLATION
J6
9.4 REMOTE CONTROL MANUAL PROGRAMMING
9.5 SELF-LEARNING REMOTE CONTROL PROGRAMMING
2048
433.92 MHz
Rolling-code algorithm
> 4 billion
antenna cable RG58
T1
T3
"Hidden key"
"Hidden key"
T2
T4