Makita DFR550 Manual De Instrucciones página 7

Reversing switch action
A
► 1 . Reversing switch lever
This tool has a reversing switch to change the direction
of rotation. Depress the reversing switch lever from the
A side for clockwise rotation or from the B side for coun-
terclockwise rotation.
When the reversing switch lever is in the neutral posi-
tion, the switch trigger cannot be pulled.
CAUTION:
• Always check the direction of rotation before
operation.
• Use the reversing switch only after the tool
comes to a complete stop. Changing the direc-
tion of rotation before the tool stops may dam-
age the tool.
• When not operating the tool, always set the
reversing switch lever to the neutral position.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
the battery cartridge is removed before carrying
out any work on the tool.
Installing or removing the bit
Loosen the thumb screws which secure the casing. Pull
out the casing in the direction of the arrow.
1
2
► 1 . Casing 2. Thumb screw
1
Press the dust cover toward the plane bearing and pull
out the bit. If the dust cover cannot be moved as far
as the plane bearing, try it again after turning the bit
slightly.
To install the bit, insert it into the socket while turning it
slightly. After installing, always make sure that the bit is
securely held in place by trying to pull it out.
B
► 1 . Plane bearing 2. Dust cover 3. Bit
Installing screw strip
Insert the screw strip through the screw guide. Then
insert it through the feeder box until the first screw
reaches the position next to the driving position.
2
► 1 . Feeder box 2. Screw strip 3. Screw guide
► 1 . Driving position
7 ENGLISH
1
2
3
1
3
1