Charging The Battery - Pulsar AXION XM30 Guia De Inicio Rapido

Charging the battery

AXION thermal imagers are supplied with a rechargeable APS3 Lithium-ion
Battery Pack which enables the thermal imager to be used for up to 3 hours.
The battery should be charged before first use.
Charging the battery
Option 1 (Fig. 2):
• Install the battery (10) into its slot on
the instrument case (14) by aligning
the icons to form a 'dot' on the unit
and the battery (see
• Attach a USB cable (15) to the
microUSB connector (8) on the device.
• Connect the other end of the USB cable
(15) to the mains charger (16) or to a
USB socket connected to another power
sources with rated output of 5V or less.
• Connect the mains charger (16) to the
mains power supply.
Note: The PB8I* Power Bank may be used as a charger.
Option 2 (Fig. 3):
• Insert the battery (10) supplied with
your unit, or purchased separately,
fully along the guide rail into the
APS* charger slot (11) (see
• Point A on the battery and Point B on
the charger should be aligned.
• Two batteries can be charged at the
same time – a second slot is provided
for this.
• Attach the microUSB plug on the USB
cable (15) to the microUSB connector
on the mains device (16). Plug the
device into a 100–240V power outlet
(17).
• Attach the second plug of the
microUSB cable to the socket (12) of
the mains charger (11).
• The LED indicator (13) will light up.
• Battery charge status (see table).
3
ENGLISH
Charger
Fig. 4).
Fig. 4).
16
15
Fig.
2
А
10
B
13
LED Indicator
17 16
Power Charger
outlet
17
Power
outlet
USB cable
MicroUSB
8
connector
Battery
Pack
А
Fig.
3
Charging
11
base
B
MicroUSB
port
12
15
USB
cable