Charging Battery Pack - Pulsar PROTON FXQ30 Guia De Inicio Rapido

Charging battery pack

The PROTON FXQ30 thermal imaging attachment
comes with an APS 5 rechargeable Lithium-ion
battery. APS 5 batteries support USB Power Delivery
fast charging technology when using a standard
charging set (charger, USB Type-C cable, power
adapter). Before first use, make sure the battery is
fully charged.
Option 1
•
Install the APS 5 battery (4) in the battery
compartment (5) of the device.
•
Connect the USB cable (21) to the USB Type-C
connector (9) of the device.
•
Connect the other end of the USB cable (21) to the
Power Adapter (22).
•
Plug the Power Adapter (22) into a 100-240 V
socket (23).
Option 2
•
Insert the APS 5 battery (4) along the guide into
the APS 5 charger (18) slot as far as it will go (see
Fig.). The APS charger is supplied with your device and
sold separately.
•
Connect the plug of the USB Type-C cable (21) to the
USB Type-C connector of the Power Adapter (20).
•
Plug the Power Adapter (22) into a 100-240 V socket
(23).
•
Connect the other end of the USB Type-C
cable (21) to the USB Type-C connector
(20) of the charger.
•
LED indicators (19) will
display the battery charge
level (see Table).
Note: Two batteries can be
charged at the same time, a
second slot is provided for it.
3
ENGLISH
9
21
22
23
23
4 22
21
4 18 19
20
LED INDICATION (19)
IN THE BATTERY CHARGING MODE
Battery charge level is
from 0% to 25%
Battery charge level is
from 26% to 50%
Battery charge level is
from 51% to 80%
Battery charge level is
from 81% to 99%
Battery is fully charged. It
can be disconnected from
the charger.
Defective battery.
Do not use the battery!
* Standby mode is when the batteries are in the charger but the Power Adapter
is not connected. In this mode, the indicators are only on for 10 seconds.
Attention! When using a Power Adapter that does not support USB Power
Delivery fast charging technology, the flicker frequency of the LED indicators
decreases by a factor of 3 and the charge time increases.
Attention! The charger heats up during fast charging. Excess heat is removed
through the radiator and does not affect the device operation.
Installing Battery Pack
•
Put the Lock-cover (3) on the rechargeable APS 5 battery (4).
•
Insert the APS 5 battery (4) along the guide into the battery compartment (5).
•
Lock the battery (4) by turning the Lock-cover (3) clockwise until it stops.
•
Turn the Lock-cover (3) counter-clockwise to remove the battery (4).
3
4
LED INDICATION (19)
IN THE STANDBY MODE*
Battery charge level is
from 0% to 25%
Battery charge level is
from 26% to 50%
Battery charge level is
from 51% to 80%
Battery charge level is
from 81% to 99%
Battery is fully charged. It
can be disconnected from
the charger.
Defective battery.
Do not use the battery!
5
ENGLISH
4