Yamaha YSP-600 Manual De Instrucciones página 77

Parameter to be changed and front panel display
MEMORY PROTECT
You can protect the settings you saved in the system memory of this unit from being
accidentally erased or unwantedly changed.
MAX VOLUME
You can set the maximum volume level so that this unit will not output sound beyond the
limited volume level.
TURN ON VOLUME
You can set the initial volume level when the power of this unit is turned on.
DEMO MODE
You can test the sound beam output from this unit to experience the sound beam.
PANEL INP. KEY
You can disable the INPUT on the front panel when you adjust the system parameters.
F.PANEL KEY
You can disable the front panel keys except when you adjust the system parameters.
FACTORY PRESET
You can reset all of the parameters of this unit to the factory presets. This procedure
completely resets ALL the parameters in SET MENU.
Note
After performing the following procedure you must run
sound environment.
7
Press STANDBY/ON on the remote control to
set this unit to the standby mode.
STANDBY/ON
AUTO SETUP
again to match your surround
The new setting will be activated when you turn on the
power of this unit next time.
y
When the demo mode is turned on, restart the unit, then press
ENTER while playing back sources to test the sound beam.
The sound beam being output shuttles between left and right.
Press ENTER again to stop shuttling.
Adjusting the system parameters
Parameter settings
ON, OFF
MAX, 99 to 01, MIN
Control step: 1
MAX, 99 to 01, OFF
Control step: 1
ON, OFF
ON, OFF
ON, OFF
RESET, CANCEL
75
En